Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Driveways and paths can be hard to spot after dark or in low light. This 3" round double-face reflector makes them easy to find. With bright blue reflective surfaces on both sides, it catches headlights from either direction, helping mark curbs, lanes, and entrances clearly. The round shape gives a clean look while standing out just enough to do its job.
Outdoor markers take a beating from weather, snow, and the occasional bump. The 35" steel rod holding this reflector is built tough to stay upright and resist bending or rust. It’s tall enough to be seen over grass or snowbanks, keeping your path visible year-round.
You don’t need anything fancy to set it up—just place the steel rod into the ground where you need visibility. Once installed, the double-face design does the rest without any maintenance or power needed. It’s a simple, long-lasting way to keep your driveway or property easily marked and safer for everyone passing through.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to be taking a look at the 3 inch round double face driveway marker reflector. This reflector is going to add safety and help indicate the location of your driveway or parking area. It is a double face blue reflector so we got the reflector on both sides. It's going to have a nice white housing that goes around the reflector and it's going to have a steel mounting pole that is strong and durable and easier to drive into the ground. The unit's going to have a holder here at the top that way you can easily hang it or store it when it's not being used. If we take a measurement of the overall length, measuring from very top to very bottom, that gives us a measurement of around 36 inches and then the pole itself, just the visible portion of the mounting pole, that's going to measure about 31 and 5/8. Right around that area, 31 and 3/4 of an inch. Now the diameter of just the reflector portion.
That's going to give us a diameter of right around 3 inches and then the overall diameter including the housing . That's going to give a measurement of about 3 and 5/16 of an inch. You'll notice that on the reflectors it says SAE and DOT so that lets us know that these are SAE and Department of Transportation compliant. That's going to do it for today's look at the 3 inch round, double face driveway marker reflector.
Ratings & Reviews
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.







Heather A.
9/9/2024
It's best to put these in the ground when the ground is softer, normally the fall is the best time for this. If the ground is really hard where you are trying to install these markers, I recommend to use a drill with a 3/8" auger bit. You could also hammer a similarly sized stake in the ground before trying to put the markers in to make a hole.