2-1/2" Diameter round. LED trailer light serves as either a side marker light or a clearance light. Pirhana series combines modern design with vibrant lighting. Recessed mount with grommet (sold separately). Accepts 2-prong plug. P2 rated.
Features:
Specs:
A P2-rated light produces a 45-degree angle of light to either side of its centerline for a total of 90 degrees of coverage. This beam pattern can be seen straight on, but it cannot be seen clearly from the side. So this type of light can be used as either a side marker light or a clearance light, but it cannot function as both. If you need both functions, then you must install 2 separate lights on your trailer - one as a front or rear clearance light and one as a side marker light.
Recessed-mount trailer lights install with a grommet, which is often sold separately. These lights extend past the trailer surface and require a hole for installation. If replacing a light, you can utilize the pre-existing hole. If installing a new light, you will need to cut a hole or use a mounting bracket (sold separately) to complete the installation.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today, we're going to take a look at the Piranha LED trailer clearance or side marker light with reflector. Now, this is an important component to have on your trailer to make sure that you're visible, even at night, and even if your trailer is parked somewhere, you want to make sure that people can still see it. You'll see our reflector there makes it easy to spot. And then, we'll also have our light itself. We plug in our two wire prong, this is sold separately. You can find it here at etrailer.com.
Then our light turns on there, and we'll be seen.This has four diodes, so one, two, three, four, and it's P2 rated. Basically, that means that from the side, we'll be able to see it at about a 45 degree angle in either direction. So, if you want to use this as a side marker light, it's only going to be good for that side, and if you want it for a clearance light, you'd have to get another one. Basically, if you think of a corner, this isn't going to reach around the corner, it's only going to be for one side of it.As far as our dimensions, the light is about 2 and 1/2 inches in diameter and about 15/16ths deep going from the face of our light to the little prongs on the back, or just under an inch. You can also pickup a grommet to go with this light to give it a little bit of road shock protection.
Kind of finishes the look of the light, and this will actually hold the light in place if you put it in to a three inch diameter hole, since it has this little lip to hold it in place, and that still allows our wiring to come through. Now, this is sold separately using part number 142-1A, and you can find that here at etrailer.com, as well.Our light, again, is P2 rated, DOT compliant, and made in the USA, and the LEDs have unlimited lifetime warranty from Peterson. And that's going to do it for our look at the Piranha LED trailer clearance or side marker light.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.