To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Most retractable covers take a lot of time and tools to install, but this one is ready to go in about 10 minutes. All you need is a wrench and screwdriver—no drilling required. The canister bolts to the bulkhead, and the side rails clamp inside the bed rails using two clamps per side. Built-in kickstands help level the rails so you don’t have to worry about overtightening or uneven fitment. When it’s time to haul something large, you can remove the entire cover just as easily and reinstall it in roughly the same 10 minutes.
When you need the whole bed for tall or oversized cargo, you can take off the Switchblade without hassle. The canister detaches from the side rails using a wrench, and the pull strap doubles as a handle for lifting it out. That means you get true full-bed capacity when needed without compromising protection when you put it back on.
Getting into your truck bed shouldn’t be a chore. Just squeeze the pinch grips under the rear plate to release the heavy-duty tension spring, and the cover glides smoothly into its canister. Re-closing is just as simple with the built-in pull strap. The movement is smooth and quick—no sticking or fighting panels—and you never lose visibility through your rear window since the cover stores neatly inside its compact canister.
Rain, dust, and debris don’t stand a chance with this durable deck. It uses a black vinyl top layer bonded to rigid aluminum slats for a seamless look that’s sleek yet strong. Water management comes from sealed rails that channel runoff into drain tubes at the canister, then out through factory holes in the bed floor. Foam seals beneath the rails and canister block out moisture along with a large rear seal that closes tightly against the tailgate.
The cover sits just 1/8" above your bed rails for a clean, aerodynamic look that cuts wind drag. With both pinch grips and pull strap hidden under the rear plate, no one can open it when your tailgate is locked. The hard aluminum slats resist prying or cutting, so your gear stays safe while the truck keeps its smooth factory lines.
Customer Satisfaction Score:
87% were satisfied with this product
13% of customers were not satisfied
Ratings & Reviews
David B.
9/15/2022
Anthony, these are weather resistant not water proof. So some waterdebridust may get in at some point. HOWEVER if it is a large amount then I would check your seals and make sure that the proper adhesives and gaskets are used and that you clean and sandpaper the mounting areas if they have any bed liner or plastics so you will get a better seal.
Jenny N.
9/23/2022
I apologize that your contact with us was not handled appropriately. Customer service will reach out to you.
William
3/25/2022
The cover works real well In all aspects I have ut On my 2018 2500 duramax but after about the 7th month the small stainless screws came out of the latch mechanism on the side rails and is impossible to roll cover out without losing latch mechanism on each side.
Brooke M.
4/20/2022
Scott
2/2/2023
Switchblade cover works great. Was easy to install. Was concerned about it working well in snow and ice. Works great. Wish the drain tube attached better to canister. They have come undone a couple of times and are kind of a pain to reattach. All in all very happy, good product.
Gary G.
9/8/2025
Update: Purchased in July 2025, it is now September 8th 2025, so basically 2 months since installed. The cover will not retract all the way. Called the manufacturer for warranty. I basically have to remove the cover and inspect the spring assembly. They will then send out a new spring assembly that I will need to install myself. This will require a fair amount of my time, which I am not happy about. This unit should not fail in two months, especially with very limited use. I would have preferred them to send a new cartridge that I could put in the truck for ease of repair. They dont care about the customer experience, apparently. Do better Pace Edwards!
Gary
7/15/2026
Outstanding, The product exceeds my expectations. The quality of this product is great. I would absolutely buy it again and have suggested it to several friends of mine who have asked how I like it.
Lazer S.
7/15/2026
Do you have a question about this Tonneau Cover?
Condition: Missing Parts
Notes: This is just the tonneau cover. The rails are not included. This works as a replacement part.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Tucker
9/25/2025
It’s been about an year now and this cover has been great no problems with it still looks new!