Ventline RV Vents and Fans
- V2119-3-533
- Vent
- Roof Vent
- 12V Fan
- Tinted
- Powered Lift
- Ventline
- Plastic and Metal
This roof vent's powered, 12-volt fan and dome lift provide the ultimate in convenience for ventilating motor homes and enclosed trailers. Fan and wedge-shaped, plastic vent cover are operated from a remote wall switch, included.
Features:
- Roof vent's electric fan yields better air circulation than non-powered models, exhausting hot air while trailer or RV remains locked and secure
- Power lift opens and closes cover, eliminating hand cranking
- Simple to upgrade from non-powered model
- Included wall remote switch provides convenient operation
- Translucent cover allows some light through
- Aerodynamic, wedge-shaped dome made of durable polypropylene
- Galvanized steel roof flange won't rust or corrode
- Snap-out screen is easy to clean
- Polar White interior trim piece (or garnish) is included
- Fan and power lift use 12-volt DC power
- Made in the USA
Specs:
- Included garnish fits roofs 2-1/8" to 3-1/4" thick
- Garnish leg length (depth): 2-1/8"
- Garnish color: Polar White
- Other garnish sizes are available (sold separately)
- Fan capacity: 100 CFM
- Fan and lift power: 12-volt DC
- Cover color: Smoke
- Rough opening size: 14-1/4" x 14-1/4"
- Vent extends above roof:
- 2-year warranty
Notes:
- Screws and sealer are not included. See Installation Kit (344270KITW), which includes all necessary screws and sealer to install vent.
- Not for use above tubs, showers or range cooking surfaces.
![V2119-603-00 roof vent]()
![remote wall switch]()
Installation Instructions
- Mark desired location for vent. Be sure to choose a location between roof joists.
- Cut a 14-1/4" x 14-1/4" opening through roof and ceiling. (Or use existing opening if you're replacing a standard 14-1/4" x 14-1/4" vent.)
- Apply sealant to bottom of flange. Be sure to surround each screw hole.
- Insert vent through hole with screen frame extending through roof cavity and hinge of vent toward the front of the vehicle.
- Mount to roof with #8 screws.
- Remove screen frame and wiring compartment cover to make electrical connections.
- Connect to 12-volt DC power source.
- Replace screen frame and cover.
- Attach interior garnish piece with #8 screws.
Ventline V2119-603-00 Roof Vent and VC0533-03-A Remote Switch
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.