Video Transcript for Lippert Controller 2.070 x 1.5: The Breakdown

Hey everyone, I'm Ellen here at etrailer.com. Now, this is going to be the Lippert Components controller. This is for the slide outs. This is going to be for the LCI above floor and through frame slide outs. Helps to control those and keep everything running smoothly. It does not come with the harness so if you need to pick one of those up, you can find that here at etrailer.com.

It's a related part on the product page here at etrailer. The part number is going to be LC135696 for that wiring. If yours is still working properly and everything's fine with those wires then you probably will be able to skip it. But, if anything's wrong with that, you can grab that wiring harness to go with this. It just plugs into this little plug at the bottom to get all those wires connected to our box.

Everything's labeled on the box as well. So we'll have our alarm, battery, ground, metered red, meter black, sewer in and sewer out connections for our wiring.I'm going to give you guys some measurements so you can see how big this is. So from outside edge to outside edge, it's about four inches long. The end of those little tabs there. The two mounting holes on either side, the distance between those center to center is about three and a half inches.

And each of those has a diameter of about three eighths of an inch, or excuse me, three sixteenths of an inch. The overall width is about two and a half inches. Height or depth, however you want to think about it is about an inch. So, should be pretty compact and fit inside your housing there. That's going to do it for our look at the Lippert Components controller for slide outs..