Replaces the V-Sync II controller for RV In-Wall slide-out. This dual motor synchronous velocity slide controller is a C2 version.

Replaces the wiring harness that works with your Lippert slide-out controller (LC135666).

Slide-out switch for replacing 1 worn or damaged slide-out switch for your RV's slide-out room. 12V 40-amp continuous momentary-on/off/momentary-on switch assembly with bezel. Assembly fits cutout measuring 1.85" tall x 1.20" wide.

Replaces the Nason hydraulic high pressure switch with Deutsch DT-04-2P all-weather connector. This component is used most commonly on Lippert hydraulic slide-out units but can also be found on hydraulic leveling systems.

Replaces the controller for your Lippert SlimRack (366697) in-wall slide out. No parking brake input required. If your slide-out requires parking brake input, LC48ED (sold separately) is the correct controller.

Replace the remote receiver in your Lippert In-Wall slide-out system with this 8-function remote receiver with replaceable fuses.

Replaces the controller for your Lippert SlimRack (366697) in-wall slide out. Parking brake input required. If your slide-out requires no parking brake input, LC68ED (sold separately) is the correct controller.

Replaces the controller for your Lippert Power Gear Ultra Torque RV slide out.

Replaces the INwall My RV control panel for your Schwintek RV slide-out.

Replaces the auto-programmable control panel for your Lippert OneControl in-wall slide-out.