To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Replaces 1 EndCap for your Yakima HD crossbars (Y01156, Y01157, Y01158, or Y01159).
Features:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Ellen: Hey, everyone. I'm Ellen here at etrailer.com, and we're going to be taking a look at the replacement end cap for your HD crossbars from Yakima. So if something happened to that original cap, it got cracked or broken off, this is going to be that direct replacement from Yakima to get you back to your original looking bars. So it's going to come in a couple of pieces because of the way it has to install on the actual load bar itself, so we can take a closer look at how that's going to go together. So we'll have a piece on either side. It's also going to come with a little bar that goes in between, so that's kind of your load tie-down point.
A lot of times we'll put straps or ropes to the end of those bars, acts as an extra loading point. You'll also get a little button cap screw and a bolt.So first thing we're going to do is take the screw and put it into this little slot. You can see how there's kind of a little space there. That's going to match up with our hex nut. And then you also want to place in that bar, because once you snap these guys together, it's going to be really hard to get either one of those things in place.
Then we can take the other side, match it up with the first. Everything should line up. There's a little ridge on this tab or this tab here, so you're going to have to kind of squeeze until they snap over. But you want to make sure that you have everything in place before you do this, because it's going to make it a lot easier. That way, you're you're not having to take it apart and do it again.There we go.
Okay, so everything is lined up now, and you can see this hole here where our nut is going to be captured. Before it was snapped over, those holes didn't really line up, so the way to know that you have it snapped all the way in is that the two holes line up so you can put in the screw. And that's going to keep everything secured together, so you don't have to worry about it coming apart. So you just tighten that down all the way until the screw runs out of threads, or until it's around your bar. So that's going to go through your bar and keep everything tight together, and keep the end cap secured to the bar itself.And that's pretty much all there is to it.
Pretty easy to get that installed. It works with all the lengths of the Yakima HD crossbars, so the complete list of part numbers is at our website here at etrailer.com, where you can also find the load bars and a lot of other accessories to go on them as well as other replacement parts. So I hope this has been helpful in deciding if this is the right piece for you, and also showing you how to get this put together to load it onto your bar. Again, I'm Ellen here at etrailer.com. Thanks for watching.
Customer Satisfaction Score:
100% were satisfied with this product
0% of customers were not satisfied
Ratings & Reviews
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Joe
3/2/2023
Perfect replacement after one of my end caps managed to come loose and fall off somewhere down by the river.