Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to take a look at the replacement 1 1/4" and 2" shank for Swagman XTC-2 series bike carriers. This part will replace the 1 1/4" shank that's on your Swagman XTC-2 series bicycle rack. Basically, one end right here, you can see, will bolt to the bike rack. Has two threaded holes right here. The other end has a threaded hitch pin hole to attach this bike rack to your hitch. It does include the threaded hitch pin and clip to secure the bike rack to your trailer hitch receiver.
Now, it also comes with a adapter sleeve right here so that that bike carrier can be used with 2" trailer hitch receivers.It does require an Allen wrench for removal and installation of the sleeve on the shank. But just to show you how that sleeve goes on, what you would do is take this section. There's two holes. One's threaded, one's smaller. Just line this up, where the bolt goes in, with the smaller hole.
Make sure it goes through the hole. And then on the other side you'll take . At the very bottom, there's a threaded small hole that'll line up with the bolt. So once you get those two lined up just like that, then go ahead and start tightening that bolt down. And then again, use your Allen wrench.
Again, the Allen wrench is not included. You would have to supply that.Once you snug that down enough and you can see those two pieces will form the adapter sleeve that allow this to slide into a 2" x 2" hitch receiver opening. Again, the application for this is this works on the Swagman XTC-2 bike carrier for the 1 1/4" and 2" trailer hitches. That bike carrier is part number S64670. We do sell that separately on our website.
Now, the length of this, from the center of the hitch pin hole right here to the base of the rack is going to be right at 17" and the total rise when this is installed in your hitch, it'll rise . give you a 3" rise for your bike rack. But that should do it for the review on the replacement 1 1/4" and 2" shank for Swagman XTC-2 series bike carriers.
Customer Satisfaction Score:
95% were satisfied with this product
5% of customers were not satisfied
Ratings & Reviews
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Mike L.
9/11/2026
Which model bike rack do you have?