Coolers

Hello Anthony. It sure does! The CVT Timber Creek Annex for Car Camping #RG35ZV will work on virtually any SUV or crossover, so it can absolutely be used on a 2024 Subaru Crosstrek.

Hi Randal! As the etrailer Hard Tonneau Cover - Folding - Fiberglass Reinforced Plastic #e98RV for your 2024 Toyota Tundra 6-1/2 Foot Bed with the Deck Rail System has weather seals on top of the bed rails, you will not need drain tubes. From what I…

Hey Janet! The 70" measurement is the overall width of the Thomas Payne Trifold RV Loveseat and Sleeper #LC34FC. The overall dimensions are 70" x 37" x 37". The sleeping surface is 60" wide x 70" long x 19" high.

Hey Chris, the good news is yes, the Roadmaster Direct-Connect Base Plate Kit #RM-524431-5 that you have for your 2020 Ford F-150 Raptor will also work for your 2025 Ford F-150 Raptor. As of right now it does not look like we have an install kit for…

The SuperSprings #SSA22 would be a smart choice to raise your 2012 Ford F-250 when pulling your fifth wheel. They are designed to prevent the sagging you are experiencing and should put you pretty close to level. If you take a look at the attached…

The main difference between a Class III hitch and a Class IV hitch is the capacities they set for the hitches. Class III hitches are rated for up to 6,000 lbs GTW with 600 lbs TW whereas a Class IV is rated for up to 12,000 lbs GTW and 1,000 TW. For…

My contact at Atwood recommended using a pin at least 3/8 in diameter and 2-3/4 inches long. I'd recommend using a snapper pin, part #JFC-PN which has those dimensions.

We offer 3/8-inch diameter Replacement Snapper Pin #JFC-PN whose measurements are noted in the photo I linked for you. This item matches the original; I confirmed by going to our warehouse and measuring the pin included with your Husky Super Brute…

My contact at Curt Manufacturing advised that they do not offer the replacement Wire Lock Lynch Pins (shown as part number 10 in their instructions, which are linked) that secure their TruTrack's trunnion bars at the head end but he said…

I went out to the warehouse and pulled Pins and Thumb Clips #EQ95-01-9415 to measure them for you. The diameter is 3/8 of an inch. The usable length is just under 2-1/2 inches (2.45 inches). And the opening is 2.46 inches by 1.5 inches.

Sorry to hear about your dissatisfaction with the Timbren #TTORTUN4 on your 2018 Toyota Tacoma. They are hollow rubber springs and can create a bumpy ride when you have a load on the truck and go over speed bumps. As for the RoadActive Suspension…

That's a good question, and the answer is pretty straightforward - yes, the RoadActive Suspension (RAS) is going to give you a smoother, less bumpy ride than the Timbrens for your 2019 Toyota Tacoma. Like you mentioned, the Timbrens do their job…

Hello Anthony. It sure does! The CVT Timber Creek Annex for Car Camping #RG35ZV will work on virtually any SUV or crossover, so it can absolutely be used on a 2024 Subaru Crosstrek.

Hi Randal! As the etrailer Hard Tonneau Cover - Folding - Fiberglass Reinforced Plastic #e98RV for your 2024 Toyota Tundra 6-1/2 Foot Bed with the Deck Rail System has weather seals on top of the bed rails, you will not need drain tubes. From what I…

Hey Janet! The 70" measurement is the overall width of the Thomas Payne Trifold RV Loveseat and Sleeper #LC34FC. The overall dimensions are 70" x 37" x 37". The sleeping surface is 60" wide x 70" long x 19" high.

Hey Chris, the good news is yes, the Roadmaster Direct-Connect Base Plate Kit #RM-524431-5 that you have for your 2020 Ford F-150 Raptor will also work for your 2025 Ford F-150 Raptor. As of right now it does not look like we have an install kit for…

The SuperSprings #SSA22 would be a smart choice to raise your 2012 Ford F-250 when pulling your fifth wheel. They are designed to prevent the sagging you are experiencing and should put you pretty close to level. If you take a look at the attached…

The main difference between a Class III hitch and a Class IV hitch is the capacities they set for the hitches. Class III hitches are rated for up to 6,000 lbs GTW with 600 lbs TW whereas a Class IV is rated for up to 12,000 lbs GTW and 1,000 TW. For…

My contact at Atwood recommended using a pin at least 3/8 in diameter and 2-3/4 inches long. I'd recommend using a snapper pin, part #JFC-PN which has those dimensions.

We offer 3/8-inch diameter Replacement Snapper Pin #JFC-PN whose measurements are noted in the photo I linked for you. This item matches the original; I confirmed by going to our warehouse and measuring the pin included with your Husky Super Brute…

My contact at Curt Manufacturing advised that they do not offer the replacement Wire Lock Lynch Pins (shown as part number 10 in their instructions, which are linked) that secure their TruTrack's trunnion bars at the head end but he said…

I went out to the warehouse and pulled Pins and Thumb Clips #EQ95-01-9415 to measure them for you. The diameter is 3/8 of an inch. The usable length is just under 2-1/2 inches (2.45 inches). And the opening is 2.46 inches by 1.5 inches.

Sorry to hear about your dissatisfaction with the Timbren #TTORTUN4 on your 2018 Toyota Tacoma. They are hollow rubber springs and can create a bumpy ride when you have a load on the truck and go over speed bumps. As for the RoadActive Suspension…

That's a good question, and the answer is pretty straightforward - yes, the RoadActive Suspension (RAS) is going to give you a smoother, less bumpy ride than the Timbrens for your 2019 Toyota Tacoma. Like you mentioned, the Timbrens do their job…