While the fit is excellent on these feet, and the finish seemed good to start, after 2 years they have corroded and bubbled underneath the black coating. For the price, I expect them to last without corroding/finish failing for longer than that. 3626227

Working great to mount my crossbars and kayak rack. 3579743

Installed on a 2025 Honda CRV with vortex aero bars that I used to have on another car. Feels solid enough to lift the car with. I love this rack.

Note that eTrailer (or Rhino Rack, not sure) recommends spacer blocks for the rear bar on CRVs, to lift it a little higher and make the rack more level front-to-back. Otherwise there's a bit of a slope to a canoe or kayak due to the slope of the roof profile. The Honda factory bars don't adjust for this and they carry my boat just fine (other than being kind of wimpy), so I don't think the spacers are needed for the Rhino Rack, either. Maybe just for aesthetics. I did not buy them. 3637781

Purchase for a 2019 Jeep Grand Cherokee, black rails. Perfect fit. 3281238

We had been shopping around for roof options for our new 2022 grand Cherokee, when we came across this. For us, the OEM mopar crossbars were ugly - extend about 6 inches from the roof. These are very low profile, and insanely sturdy. Additionally, installation is crazy simple.

The only recommendation we have that differs from the instructions - we used the rear set of mounting holes on the factory rails. Using the front set of holes as recommended by the instructions for cross bars meant that ski racks would be too close together, and the ski bindings would not fit. Other than that, very satisfied! 1451200

These Rhino-Rack products are solid. Installation was quite simple. It took me no more than 2 hours from taking off the OEM rails to getting the crossbars to tighten down.

Keep in mind that these legs were designed for the Toyota Prado (it even says so on the installation guide). Once you remove the Lexus OEM rails, you will notice a groove, about 3/4" deep and 1-1/8" wide, alongside the roof. If your GX does not come with the OEM rails, the grooves might already be covered up by the factory drip trim pieces (Toyota PN 75557-60050, 75555-60030). This Rhino rack kit does not come with any hardware to cover up the grooves. I was told they would not cause any leaks because the mounting points are tightly sealed.

But if you have severe OCD like me, those grooves will be bothering you (even though you can't see them). Instead of paying over $xxx for the OEM trims pieces. Fill them up with some 3/4"wide 3/8 inch thick insulation tape, then tape a strip of 1" wide, 1/8" thick neoprene rubber strip on top. The end product looks just like OEM. I hope my simple idea will help other fellow OCD survivors. 1172663

Everything came promptly, no issues. Everything fit and the videos from eTrailer are a great help! 3524856

I searched a lot of websites before finding what I needed on etrailer.com for my 2012 Suzuki GV. I was looking for the proper mounts to install a Kayak rack system. Because my vehicle has a built in rail system it was very confusing what was needed. Thank you etrailer for hooking me up with the appropriate parts for the Rhino system, it worked great! 994050

Great item, pretty easy to install. I posted a longer review for the full setup on our 2019 Highlander with 2 biggish kayaks under reviews for the rack pillars, Item: RRRCL4. When fully tied down, we used hood loops front and rear for both boats.

Great service from Carol C. 669379

I AM SO PLEASED W/MY PURCHASE AND THANKS TO ETRAILER THE WHOLE PROCESS OF SELECTING WAS MADE EFFORTLESS W/THE STAFF ONLINE AS WELL AS VIA PHONE.
THE VIDEOS ARE INCREDIBLY USEFUL AND SO PRECISE AS TO INSTALLATION AND IN HELPING TO CHOOSE THE CORRECT ITEM FOR THE PARTICULAR AUTO DRIVEN. THE REPRESENTIVE, NICOLE WAS VERY KNOWLEDGEABLE AND SO CONCERNED TO GIVE YOU THE BEST SERVICE POSSIBLE. ETRAILER...PROFESSIONAL....TOP VALUE....A PLEASURE TO DO BUSINESS WITH. 913560

Love etrailer. They always have anything and everything you need and always at a great price. Also great videos and tutorials to help with your DIY install! Salvaged my old Rhino Aerobars with a new Rhino roof kit from etrailer for my Bolt. 940289

Well made parts, shipped quickly. I was able to install the rack with no problems by following the instructions. Good choice if you want a quality roof rack for $xxx less than a comparable Thule or Yakima. 1330044

Price, Quality, communication, Shipping Speed. Everything about this is excellent! 1285785

Fitment is good, did not come with security capscrews even it included a security wrench. The rack can be removed with allen wrench.
When rack is in place, I cannot use the sunroof on 2023 Buick Enclave.
Otherwise, it works fine! 1611925

Item arrived on time. 3573553

Perfect fit. Mounted easily to aftermarket roof rails. 893456

Terrible hardware. Screws broke inside fixed mounts twice rendering while system completely useless 3408884

Looks amazing, and was super easy to install.
2021 Jeep Grand Cherokee L 4x4 Limited 1348182

Product arrived earlier than expected with all parts. A little work to install but everything fits perfectly. After I dry fit the parts and then tightened the sliders to the cross bars I attached the rack to the mounting brackets on the roof using a 10mm wrench. It was easier access than trying to use the allen head wrench. It's on with a solid fit and I love it. 1198826

Two stars because the provided hardware interferes with the factory rails when using the provided cover plates (to be installed when you remove the cross bars & towers). Had to source my own 12mm long cap screws because provided 16mm were too long. Otherwise works as advertised. 1267063

I purchased the Rhino Rack roof rack as an alternative to the factory installed products and the more popular Thule and Yakima brands. The Rhino Rack is solid and sleek and is largely silent while driving (if I have the roof open you can hear a soft whistle). Not only does the rack look fantastic, but the non-slip top and the strong bars make carrying things on top a real pleasure. 837665

The Rhino rack for my Rav4 hybrid fit perfectly and has been used extensively for carrying whitewater and touring kayaks since installing it one year ago.

etrailer videos were helpful while I shopped for alternatives to Thule and Yakima which did not offer the specific feet I needed to install their racks. 1755131

Update to my review: etrailer sent additional strips to set into the gaps on the bottom side of the rails and there is no longer any whistling, so I've rerated my purchase to Excellent. I'm not sure if the strips for the bottom side (the side that faces the roof of the car) should have come with my rails to begin with or if they need to be purchased separately (etrailer sent them to me at no charge after my initial review). Covering those gaps with duct tape will also do the trick. 1675275

Custom RCP Fit Kit was perfect for my 2018 Chevy Bolt. Screws fit perfectly in the predrilled holes on the Bolt's pVery solid and holds my 80 lb tandem kayak mounted upside down on my rhino rack cross bars with 2 tie down straps over the kayak, and a front strap attached to a loop strap held in pace by the hood. I attached the rear strap to my bike rack trailer hitch. Maiden voyage this past weekend to a spring run 45 minutes from home. Kayak didn't even budge an inch. Rubber on the surface of my rhino racks prevented any slippage. 1618955

I had tried to buy OEM Cross Bars for my '21 Cadillac XT6, but no one had them, and it looked like a long term problem of availability from Cadillac. So- after ordering and receiving some cheap bars that the ad on (that auction site) said were a "perfect fit", and finding them to be 1/2" short of reaching between the rails, then returning them for credit (but not for the shipping!), I contacted etrailer.

I have a Thule Cargo Box that I bought from them in 2016. I use this for one long trip (1900 miles each way, every year.)

Kaylyn at etrailer researched quite extensively for cross bars that would meet my needs: strong, nice appearance and above all quiet! She got back to me a day later, recommending Rhino Rack Aero Bars, and the attachments as being the best available. She cautioned me that (like any aftermarket bars) they would not be as quiet as OEM flush fit bars. I value honesty.

I installed them, and found the kit to be very complete. See the pictures- it looks great as far as I am concerned. And they are virtually silent at up to 70 MPH (I'll try them faster when we leave!). One caution: do not forget the plastic "Measuring Strips"- they are IN the bars, and are marked for measuring. But the real purpose is to seal the BOTTOM of the cross bars to eliminate "loud whistling"- ask how I know. 1207358