JR Products hold-down bar is designed to secure LP tanks. The bar is notched to accept three sizes of LP tanks with a center hole measuring 1/2" in diameter.
Features:
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Presenter Hi there, propane users. Today, we're gonna be taking a look at replacement propane tank hold down bars. This one here is specifically designed to work with 20 and 30 pound tanks and is a direct replacement for the full system that you can buy here at etrailer that's exclusive from JR Products. The hold down bar can sometimes get lost when you're replacing your tanks, you can misplace it and drive off, and then it's no longer there. And you need one to ensure that you have your tanks properly secured. Replacement ones are available here at etrailer.
This hold down bar for your propane tank is about a foot in length and is designed to work with 20 and 30 pound tanks. The distance between our hold-down notches here is you're gonna have three different kind of distance settings. The current one we have here, we're using the middle notch with, but just depending on your trailer and the base where your tanks sit, they may seat slightly closer or further apart. The distance between the outer set of holes is going to be 10 3/4 of an inch. So you can check your tanks to see if this is gonna work.
The middle slot is gonna be 9 1/4 inch, so it's about an inch and a half difference. And then another inch and a half closer together for our third and closest distance, which is going to be 7 3/4 of an inch. There's a hole in the center of our bar for our threaded rod to pass through. And you'll secure your tanks using a wing nut, pushing down on our hold down bar. You can get replacement threaded rods, as well as wing nuts, here at etrailer, in case you happen to have been loaded in a trailer, had an accident, or maybe it's just been in storage for a really long time and corrosion has taken its toll.
And that completes our look at the replacement propane tank hold down bar..
Average Customer Rating: 4.9 out of 5 stars (16 Customer Reviews)
JR Products hold-down bar is designed to secure LP tanks. The bar is notched to accept three sizes of LP tanks with a center hole measuring 1/2" in diameter.Just the parts I needed after a rookie mistake backing up, didn’t need to order from two places
Everything was perfect for my applicati on
I spent a few hours without any luck searching local retailers for a new hold-down bar for the two propane tanks on my trailer. The solution? etrailer! The part was on its way the same day I ordered it, and I received it before I was on the road again. It's a very sturdy steel bar and meets my need perfectly.
Great Fast Shipping
Very fast delivery and great products.I will be back again when I need something. Thank You!
Thanks for the prompt service..
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.