Wiring Diagram for the Bulldog Powered-Drive Kit # BD1824200100
Question:
Can I mount the unit on the left side? It would be better because of the spare tire on the right side. The picture shows it on the left. IN that case, I would believe the black would become the positive for the switch. Please advise about how to wire using the terminal box. I dont understand what wires go where?
asked by: Harvey S
Expert Reply:
I spoke to my contact at Bulldog and he informed me that the Bulldog Powered Drive Kit part # BD1824200100 that you referenced can only be installed on the driver side of the trailer due to how the gears of the jack setup.
To see how it all wires up check out the wiring diagram I attached that I took from the installation instructions for this kit.
Jameson C.
12/18/2024
Jameson C.
12/18/2024
Product Page this Question was Asked From
Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Powered-Drive Kit
- Bulldog
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Video: Installing the Dexter Torflex Lift Kit
- Shop: Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
- Shop: Camco RV Polyethylene Propane Tank Cover for (1) 20-lb Steel Tank - Black
- Shop: Advent Air RV Air Conditioner - 15,000 Btu - Black
- Shop: Empire Faucets RV Handheld Shower Set w/ Slide Bar - 2 Function - Brushed Nickel
- Shop: Bulldog Collar-Lok Coupler w/ High-Profile Latch - 2-5/16" Ball - 3" Tongue - 12,500 lbs
- Shop: Torflex Lift Kit - Tandem Axle - 2-5/8" Lift
- Shop: Torflex Lift Kit - Tandem Axle - 3-1/8" Lift
- Search Results: 2 5/16 coupler
- Search Results: torsion axle lift kit
- Search Results: stabilizer jack motor
- Search Results: bh82516
- Search Results: bd1824200100
- Search Results: sewer hose
- Search Results: demco hitch parts
- Video: Ultimate Overview of the Lionshead Trailer Wheel Lug Nut
- Q&A: Determining Correct Replacement Hubs for Dexter 8-286 Hubs on 2,500 Pound Axle
- Article: Pintle-Hitches
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Trailer Wheel with Bolt Pattern 5 on 4-3/4 inches
- Video: Bulldog Powered-Drive Kit Review
- Q&A: Installation Instructions for Bulldog Powered-Drive Kit # BD1824200100
- Q&A: How to Pick Out Replacement Bearings/Races for a Wesco Boat Trailer
- Q&A: Using 1 or 2 Electric Jack Motors for Bulldog Single Speed Jacks with 12,000 Pound Capacity
- Q&A: How to Tell if a Bulldog 10K/12K Jack is a Single Speed or 2-Speed
- Q&A: Can Bulldog 12,000lb Trailer Jack Be Adapted To Be Raised/Lowered With Electric Impact?
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
Eric
12/17/2024
there are only white and black wires coming from the motor??