Troubleshooting Trailer Brake Module Fault on 2008 Ford F-250 w/ a Factory Controller
Updated 05/07/2025 | Published 05/02/2025
Products Featured in This Question
Question:
I have a 2008 F-250 4x4 6.4 litre engine and I get trailer brake module come up on my screen then my brakes lock up, now theyre staying locked up. Is the a relief for this that isnt going to cost me an arm and a leg?
asked by: Jeff C
Expert Reply:
Are you talking about the factory brake controller? If so it sounds like you may have a short in the wiring on your 2008 Ford F-250. You can use a Multimeter like item # PT29ZR to check this at your 7-way by checking for continuity with the brake wire and any other wire on the 7-way. You can see the terminals in the image below.
If this is a factory controller, I recommend checking with your local dealer as well to see if there are any required re-flashes needed for it.
Have you checked your brake away kit? The plunger may have come out or it could've gone bad, dead battery, bad wiring, etc.
What kind of brake controller do you have?
(click to enlarge)
Product Page this Question was Asked From
Curt 7-Way to RV Socket LED Circuit Tester - Vehicle End
- Electrical Tools
- Testers
- Circuit Tester
- Tow Function Tester
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: brake controller
- Search Results: gooseneck chain hooks
- Search Results: stake pockets tie down anchors
- Search Results: chain hooks
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller w/ Custom Harness - Up to 4 Axles - Proportional
- Search Results: b&w gooseneck
- Search Results: gnrk1108
- Shop: Curt Spectrum Brake Controller w/ Custom Harness - Dash Mounted Knob - Up to 4 Axles - Proportional
- Shop: Curt Spectrum Brake Controller w/ Custom Harness - Dash Mounted Knob - Up to 4 Axles - Proportional
- Q&A: How to Bypass Factory Integrated Brake Controller in 2010 Ford F-250
- Shop: Tekonsha Primus IQ Trailer Brake Controller w/ Custom Harness - 1 to 3 Axles - Proportional
- Q&A: Will 2008 Ford F-350 Integrated Brake Controller Work with Electric Over Hydraulic Brakes
- Shop: Weigh Safe Safe Load Gooseneck Ball for B&W Turnoverball Hitches - 30K
- Video: Feature Review Durabilt Ratchet Chain Binder w/ Multiple Hooks for 3/8" to 1/2" Chains
- Video: How to Choose a Trailer Brake Controller
- Video: Feature Breakdown: BulletProof Hitches 1/2" Safety Chains with Clevis Hooks
- Video: Deutsche Hydrapro Alpha G-1600 Electric Over Hydraulic Actuator Installation - 2020 Grand Design Mom
- Video: HydraStar Electric Over Hydraulic Disc Brake Actuator Installation
- Shop: Westlake ST235/85R16 Radial Trailer Tire - Load Range G
- Shop: Durabilt Ratchet Chain Binder w/ Multiple Hooks for 3/8" to 1/2" Chain - 8,800 lbs
- Video: Gooseneck Trailer Hitch Installation - 2008 Ford F-450
- Q&A: Troubleshooting Short Code and Clicking Sound with Prodigy P2 When Manual Override Level is Used
- Q&A: 12-Volt Accessory Power Feed on 2008 Ford F250 is Not Charging Travel Trailer Battery
- Video: What to Know About the Curt Echo In-Line Bluetooth Brake Controller w/ OneControl App
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Q&A: How To Install The Roadmaster Diode Wiring Kit # RM-15267 On A 2024 Ford F-250
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
on Automotive Tools
Jeff C.
5/6/2025
it is factory installed