Recommended Flat Tow Wiring for a 2024 Jeep Gladiator with LED Tail Lights

Question:

Hello, I have a 2024 Jeep Gladiator. I’m wanting to set it up for flat towing behind my motorhome. It has factory LED tail lights. I was wondering if one tail light wiring kit was preferred over another for the LED setup. Plug and play or diode kit? Thanks for your help.

asked by: Todd P

Expert Reply:

Thanks for reaching out, Todd!

The flat tow wiring kit I recommend for the LED tail lights on your 2024 Jeep Gladiator is the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit, and the correct part depends on if your Gladiator has the ParkSense feature or not:

- With ParkSense # RM63MR
- Without ParkSense # RM-15267

I think since you have the LEDs that you're supposed to have the ParkSense, but it's best to double check since the ParkSense kit has different diodes to help the lights to work correctly.

expert reply by: Jon G

Todd P.

8/26/2024

Thanks for your reply. My Jeep does not have sensors in the rear bumper, so it’s probably safe to assume I don’t have park sense correct?

Jon G.

8/26/2024

@ToddP From my understanding the ParkSense feature has sensors at the back so if your Gladiator doesn't have them then I believe you're correct that you don't have it.

Todd P.

8/27/2024

Thanks for your help, I will give that a try!