Can SoftStartRV be Used on Coleman Mach Q RV AC Units

Question

Question:

Im buying a new trailer with 2, Coleman Mach Q AC units. It seems like the soft starts are somewhat universal? Is this what I need? SoftStartRV Soft Start for 2 Air Conditioner Setup - 1 Pair - SSR44FR

asked by: Gary L

0

Expert Reply:

Yes the SoftStartRV like the part # SSR44FR which is a pair of them is universal and would work great on Coleman Mach Q units as like you noticed these are universal.

expert reply by: Jameson C

0

Answer 1

The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 4-Point Set #LC358590 has 4 35-amp fuses located on the controller. Attched is a complete wiring diagram for you to check out.

view full answer...

Answer 2

I am sorry to hear about the issue you are having with your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part #LC358590. The first thing you are going to want to do is check for blown fuses on the control board. If the fuses are…

view full answer...

Answer 3

For a 13,500 btu AC unit like the Dometic Brisk Air 2 you'd need a starting wattage of right at 3,000 watts. For that your best option is the A-iPower 3,800-Watt Portable Inverter Generators - 3,000 Running Watts - Gas - Manual Start…

view full answer...

Answer 4

If you're getting a RR or LR fault code with your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote #LC358590 or #LC675817, then that is indicating that there is an error at that specific jack (right rear /…

view full answer...

Answer 5

While we do not have a picture showing this harness installed, I can tell you that the Replacement Hall Effects Wiring Harness #LC347013 you're looking at does go from the controller directly to the jacks on the left side and #LC347012 would go…

view full answer...

Answer 6

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

view full answer...

Answer 7

Hey David, The LaSalle Bristol RV Roof Replacement Kit w/ XTRM Membrane #344270KIT30 does need to be installed on a clean surface per the installation instructions: - Make sure the deck is clear of all debris. NOTE: XTRM PLY membrane must be…

view full answer...

Answer 8

Hey Ray. The Active Controls ActiveStart Plug-In Soft Start for RVs item #AS44FR is designed and assembled in Pompano Beach, Florida. The individual components are sourced from all over. It ships from our warehouse in Wentzville, Missouri and has a…

view full answer...

Answer 9

Hey Gary, so we don't carry that brand of soft start for RV AC units but we do have the Softstart brand like the part #SSR54FR for a single zone or part #SSR44FR for a dual zone setup. These reduce the amperage requirement on startup by 70…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

Yes the SoftStartRV like the part #SSR44FR which is a pair of them is universal and would work great on Coleman Mach Q units as like you noticed these are universal.

view full answer...

Can SoftStartRV be Used on Coleman Mach Q RV AC Units

Product Page this Question was Asked From

Continue Researching