Generator Recommendation for RV with 13,500 btu AC Unit

Question

Question:

Will the AI SUA2300I RUN A Dometic Briskair2 13500 BTU RV AC?

asked by: Mike

0

Expert Reply:

For a 13,500 btu AC unit like the Dometic Brisk Air 2 you'd need a starting wattage of right at 3,000 watts. For that your best option is the A-iPower 3,800-Watt Portable Inverter Generators - 3,000 Running Watts - Gas - Manual Start # 289-SUA2000i-2.

The # 289-SUA2300I does not have the wattage you'd need as it can only put out 2,300 starting watts.

expert reply by: Jameson C

0

Answer 1

Hey Mark, Although the Active Controls #AS97FR is designed for RV applications it can work on a 20 amp house circuit for you. Its bread and butter is AC units but works great with refrigerators or other appliances that are causing that circuit to…

view full answer...

Answer 2

The distance between the mounting holes is going to be the same between each one, or between each set. Center on center, they're going to be separated by 3 inches and the mounting holes are going to have a diameter of 1/2 inch. The channel width…

view full answer...

Answer 3

Truck campers are certainly a cool, niche way to go rv'ing, and I can understand why you'd want some additional clearance getting past that wheel well on your dually Ford F-350 to make the experience even more enjoyable. The #LC182496 hinge…

view full answer...

Answer 4

The TorkLift Custom Frame-Mounted Camper Tie-Downs, #TLD2140 and #TLD3113, front and rear will fit your 2020 Ram 2500, tie-down inserts, frame brackets, and all necessary hardware is included. As for turnbuckles there is a wide selection at varying…

view full answer...

Answer 5

You are correct about the TorkLift frame-mounted camper tie-downs that fit your 2012 Ram 2500 4WD with a 6-1/2 foot bed, though they only fit if you do NOT have running boards or steps underneath the truck bed. They fit 2010-2013, with the parts for…

view full answer...

Answer 6

view full answer...

Answer 7

A 13,500 btu air conditioner normally draws right at 1,300 watts which the solar panel kit part #34282184 can only provide up to 380 watts at peak performance. The highest wattage setup we have from solar panels is the #34282185 which is capable of…

view full answer...

Answer 8

The reason the part #BP05 has a hole in the center of it is so that the recessed D-ring part #RR05 can fit into it. Without the hole the D-ring wouldn't fit it. If you are wanting a similar backing plate for a different application the #RR2K…

view full answer...

Answer 9

The Brophy D-Ring Tie Down Anchor - Bolt-On #RR05 are rated for 1600 lbs each and will work very well for your 1933 Ford Hotrod. The backing plate is sold separately and is part #BP05. I've attached a photo with the dimensions to assist. Hardware…

view full answer...

Answer 10

A keen observation indeed, Brett. The mounting hole spacing on the Square D-Ring Tie-Down Anchor #ABS69FR is 3" horizontally and 3-1/4" vertically. I edited a picture for you to help illustrate.

view full answer...

Answer 11

I believe you are asking if the Go Power Eco Solar Charging System part #34273837 has a diode in it to prevent the battery from backfeeding to the panel which it does.

view full answer...

Answer 12

Yes, basically all A-frame trailers are going to have the same bolt pattern for installing a trailer jack. Typically the jacks have mounting holes that are somewhat slotted too to help with some variances. The bolt pattern you mentioned having on…

view full answer...

Generator Recommendation for RV with 13,500 btu AC Unit

Continue Researching