Correct Replacement Mounting Clamp for a Thule Hyper XL Cargo Box

Question

Question:

Hi, Is the correct part of. Hyper XL? TH7521484001

asked by: Jason G

0

Expert Reply:

The Replacement AcuTight Mounting Hardware with Screw part # TH7521484001 I confirmed with Thule is correct for a Thule Hyper XL Cargo Box.

expert reply by: Conner L

0

Answer 1

To replace the Mounting Assembly for the Thule Sonic Large, you'll need: Thule AcuTight Mounting Hardware Clamp, part #TH7521484001 Thule Replacement Cradle for AcuTight Mounting Hardware, part #TH8523387001

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

James, the Replacement Quick Grip Mount Assembly #TH05738 comes with the complete Quick Grip mount assembly. I'm not too sure what top and bottom pieces you're referring to, but if you need a replacement Quick Grip this is all you'd need.…

view full answer...

Answer 5

Thank you for the picture! So right off I can say that you will need to get more than 1 of the Replacement Cradle #TH8523387001. Since it's a different design than the other 3 I recommend picking up 2 of these and using them for the Quick Grip…

view full answer...

Answer 6

Yes, we do! To add a set of crossbars to your 2024 Toyota Sienna, I recommend the Malone AirFlow2 Roof Rack - Aero Crossbars - Raised Side Rails item #MAL74AR. These have a 165 lbs capacity and attach to your rails with rubber-coated stainless steel…

view full answer...

Answer 7

The Quick Grip Cradles #TH8523387001 referenced in your question will go underneath the crossbars on your vehicle. When the knob is turned on the Quick Grip Mounts #TH05738, the clamps will close around the cradle and press it against the crossbar.…

view full answer...

Answer 8

You can't just replace the rubber pieces you will need to replace the entire clamp. Which clamp you need depends on which Thule box you have. If your box is the Thule Pulse Alpine (613), Pulse Medium (614), or Pulse Large (615) you will want the…

view full answer...

Answer 9

Arthur, it looks like that is a rebranded Thule Force cargo box, so the Replacement Quick Grip Mount Assembly #TH05738 should work fine.

view full answer...

Answer 10

Would you be able to send me some photos of your roof box and the area where the mounting hardware is installed? If you have a newer Thule/MB cargo box then the Replacement Quick Grip Mount Assembly #TH05738 should work but if I could see some photos…

view full answer...

Correct Replacement Mounting Clamp for a Thule Hyper XL Cargo Box

Product Page this Question was Asked From

Continue Researching