Troubleshooting MaxxFan Vent Working with Remote But Not with Buttons On Fan

Question

Question:

will this fix a fan where the remote works fine. But the buttons on the fan dont work. thanks

asked by: Paul

0

Expert Reply:

I reached out to my contact at MaxxAir and he said if the remote on your 12V Fan is working fine to operate the unit but the buttons on the fan itself don't work it very well be a bad circuit board. The Replacement Printed Circuit Board # MA10A21275K that you were looking at is the correct part as long as you have the # MA00-04500K, # MA00-07000K, or # MA00-07500K model fan.

He did also say that it could just be the actual keypad on the fan too. You might just inspect the key pad to make sure you don't see any physical damage around the buttons or signs that water may have crept inside. There unfortunately isn't a separate replacement part for this component available.

expert reply by: Chris R

0

Answer 1

If your MaxxFan Plus 4-Speed Roof Vent with White Lid #MA00-04751KSX isn't lifting electronically or manually then your lift arm or operator #MA10-20281K-1AF is most likely broken and would need to be replaced. The gear inside these are notorious…

view full answer...

Answer 2

Thank you for the question! Would you be able to expand on your situation a little more so I can better help you? Just wondering if it isn't turning off when you press the power button or does it have to do with the thermostat (provided that your…

view full answer...

Answer 3

It sounds like the circuit board may be the issue with your MaxxFan Plus Item #MA00-04000K not turning off. You can try disconnecting the power wire to it, wait about 5 minutes and reconnect it. This should reset the board. If that doesn't work I…

view full answer...

Answer 4

If your MaxxFan Plus Roof Vent #MA00-04000K isn't responding at all to the remote then most likely it just needs to be replaced with part #MA00A01150K or the batteries are just in need of a change. I do also recommend verifying that you're…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Doug, That's a good question because fit is really important so the cover stays snug on your trailer, and there is a specific way to measure for the etrailer covers. It's pretty simple, and what you want to do is measure the body of the…

view full answer...

Answer 8

Hi Mike, The Karrier ST205/75R15 Radial Trailer Tire with 15" Aluminum Wheel #KE63JR does not come balanced, but it's pretty easy to do so. All you need to do is use the Counteract Tire Balancing Beads Single Pack for Trailers #CA66VR. You…

view full answer...

Answer 9

Hey George, it should fit! It's going to depend on the size of the factory crossbars on your 2024 Toyota 4Runner. The Inno Roof Deck Platform Rack item #INA510 will work with crossbars up to 3-1/2" wide x 1-3/8" tall. You'll also…

view full answer...

Troubleshooting MaxxFan Vent Working with Remote But Not with Buttons On Fan

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching