Converting 1994 Jayco Camper From Hydraulic Brakes to Electric Brakes

Updated 07/09/2019 | Published 07/08/2019

Products Featured in This Question

Dexter Trailer Hub and Drum Assembly for 2,200-lb Axles - 7" Diameter - 4 on 4

(1047)

$143.11

Wiring Kit for Hydrastar Electric Over Hydraulic Actuators

(10)

$83.96

Question:

I just want to make sure Im getting everything I need to switch from hydraulic to electric brakes on my 1994 jayco 1208. Any info would be greatly appreciated thank you.

asked by: David B

Expert Reply:

I have attached a great article at the bottom of this page that details all the components needed to install electric brakes on a trailer. The particular parts you need will depend on the camper's axle capacity along with the inner and outer bearings that are used on your existing hubs. This is needed to determine the correct hub and drum assemblies that will fit the spindles on the axle.

If you can tell me the inner and outer bearing numbers, which should be stamped right inside the bearings themselves, I will be happy to recommend specific hub assemblies.

In general though to make this conversion you will need the mentioned hubs, the electric brake assemblies themselves, wiring, and a brake controller on the tow vehicle. If the trailer isn't already equipped with a 7-Way connector I recommend using the Trailer Wiring Upgrade Kit # HS381-9000 that includes the 7-Way and wiring along with a junction box to allow for an organized setup.

If you can tell me what vehicle you plan on towing the trailer with I can also recommend the specific components you will need to add to it, such as the brake controller and 7-Way harness.

expert reply by: Chris R