Replacement for a Samsung Microwave MR5493G In An RV

Question

Question:

Hello, What are the actual dimensions of the microwave with the trim kit? I am replacing a Samsung MR5493G. That microwave was 20 1/4inch x 14inch x 14. The trim kit with that microwave is 23inch wide x 17inch high. My cabinet opening is 21 1/4inch wide x 15inch high.

asked by: Ryan B

0

Expert Reply:

The Greystone Built-in Microwave part # 324-000105 is 23-3/8" wide x 15" tall x 13-1/2" deep with the trim kit and 19" wide x 12" tall x 13-1/2" deep without the trim kit. Therefore, the Greystone Built-in Microwave will be a perfect match to replace your Samsung Microwave MR5493G.

expert reply by: Conner L

0

Answer 1

That is a Venture/ADTH motor and gear box, and what you use to replace it is a motor and gear box from Stromberg Carlson, which are the following part numbers: - Replacement Motor #LG-142178 - Replacement Aluminum Gearbox #LG-179015

view full answer...

Answer 2

The closest RV microwave we carry to match the dimensions of your Samsung MR1032UBC microwave is the Greystone Standard RV Microwave w/ Trim Kit #324-000105. The trim kit will cover the width of your your opening but will not completely cover the…

view full answer...

Answer 3

Without knowing the dimensions of your current microwave I cannot recommend a specific unit however; I can provide a link to all the RV microwaves we carry, which have the dimensions of each listed. Like the Greystone Standard RV Microwave Item…

view full answer...

Answer 4

You are certainly not alone in looking for a way to reduce the amount of sway and body roll when driving a motor home but there are great solutions to remedy those white-knuckle moments when going side-by-side with a semi or meeting crosswinds. The…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The best replacement we have for the Sylvania Microwave SR-11092B is going to be the Greystone Microwave part #324-000105. This microwave comes with its own frame that will need to be used but it should cover your cut out so you will never be able to…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Replacement for a Samsung Microwave MR5493G In An RV

Product Page this Question was Asked From

Continue Researching