How to Determine the Wire Functions for 7-Way Trailer Connector on a 2002 Dodge Ram 1500
Updated 06/28/2018 | Published 06/27/2018
Products Featured in This Question
Question:
Im trying to hook up a 7 way plug on a dodge ram 1500, its a 2002. The truck originally had a factory 7 way plug but the factory connector has been cut off and not sure which color wire gos to with pin on the 7 way. Any help would be much appreciated.
asked by: Jake L
Helpful Expert Reply:
The only way to know for sure what the functions of the factory wires are on your 2002 Dodge Ram 1500 is to test them with a circuit tester such as # PTW2993 or a meter if you have one.
Testing the light functions is easy. have someone sit in the truck to operate the lights while you test the wires at the back of the truck. I recommend writing down or labeling the wires for future reference. That will take care of the running lights, turn signals/brake lights, and potentially the reverse lights. But be sure that the emergency brake is on, wheels are chocked, and the person in the truck is holding the brake pedal down while you are testing for reverse lights. Safety first!
There will also be a 12-volt power wire which will have constant power. The truck may have to be on for it to have power though.
The 2 most difficult wires to test are the ground and the brake output wire. If you have a brake controller, then it makes it easy. You would just have someone apply the manual override on the brake controller (on and off, on and off) to find the right wire. That would leave the last wire as the ground. The brake output wire is likely going to be a blue wire.
If you do not have a brake controller, then what you can do is use a separate 12-volt battery and carefully touch one of those 2 wires to the positive terminal. Then, in the truck cab where a brake controller plugs in (see video for location) you can test the terminals to see which one has power. Have some one touch and remove the wire slowly but repeatedly from the battery to ensure you have found the correct wire. Once you have found it the last wire is the ground.
Product Page this Question was Asked From
Hopkins Endurance Quick-Install 7-Way Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- No Converter
- No Tow Package
- 7 Blade
- Plug and Lead
- Plug-In
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Search Results: bearing 25580 trailer bearings races seals caps
- Shop: Vehicle Tow Bar Brake System
- Shop: Demco Stay-IN-Play Duo Braking System for RVs w/ Hydraulic Brakes - Wireless Monitor - Proportional
- Search Results: 76419
- Search Results: f1413040134
- Search Results: 1413040134
- Shop: Demco Surge Brake Actuator w Drop and Electric Lockout - Disc - Zinc - 2-5/16" Ball - 12.5K
- Search Results: k68~001~00
- Search Results: 4813100
- Search Results: fhdpb340301
- Shop: Base Plate for Tow Bar
- Shop: Vehicle Tow Bar Wiring
- Shop: Kodiak Disc Brake Caliper - Dacromet - 7,000 lbs to 8,000 lbs
- Shop: Demco eZ-Latch Gooseneck Coupler - Square Inner Tube - 2-5/16" Ball - 30K GTW
- Shop: Roadmaster Smart Diode Kit for Variable Voltage LED Tail Lights
- Shop: Dexter Nev-R-Adjust Electric Trailer Brake Assembly - 12" - Right Hand - 7,000 lbs
- Video: Roadmaster Variable Voltage LED Tail Lights Wiring Kit DIY Installation - 2024 Jeep Grand Cherokee
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Fifth Wheel Hitch
- Q&A: Brake Pads For Kodiak 250 Calipers
- Video: Review of Valcrum Trailer Bearings Races Seals Caps - Caps - VA45JR
- Video: Kodiak 13" Hub and Rotor Spec Review
- Video: Detailed Breakdown of the Valcrum Threaded Aluminum Grease Cap for 6K to 9K Axles
- Video: Review of Kodiak Trailer Bearings Races Seals Caps - Caps - KPCAP
- Shop: Gooseneck Hitch
- Video: Ventline E-Z Lift Ventadome Trailer Roof Vent Feature Review
- Q&A: Recommendation for Trailer Brakes On a 16 Foot Enclosed Trailer with 2 Axles And 5,000 LB GVW
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
on Custom Fit Vehicle Wiring
