Recommended Trailer Hitch and Wiring for 2005 Toyota Sienna  

Question:

Expert Reply:

I do have a great option for you, however the Draw-Tite Max-Frame Trailer Hitch Receiver # 75278 referenced in your question will not fit your 2005 Toyota Sienna. This particular hitch is designed for certain model Pontiac, Chevy, and Buick vehicles and will not line up with the frame of your Sienna.

For your vehicle, I instead recommend the Draw-Tite Class III Max Frame # 75237. This Class III hitch is confirmed to fit your 2005 Toyota Sienna and will use existing holes in its frame for a no-drill installation. It will provide you with a 2 inch receiver opening and features a 4,500 pound towing capacity. You will also want to check the owner's manual for the vehicle's specific towing limits, as you will need to follow whichever capacity is lower (the vehicle's or the hitch's).

I have attached an installation video on a later model year Sienna that you can use for reference, along with the written instructions for you to check out.

If you plan on towing a trailer, you will also need to install a wiring harness. For this, I recommend the Tekonsha T-One Vehicle Wiring Harness # 118304. This custom harness will install by plugging into built-in ports located behind the driver and passenger side tail lights. This will give you a 4-Way connector at the rear bumper to connect with and power a trailer's basic signal lights.

I have included an installation video on your 2005 Sienna.

Lastly, you will need a ball mount and hitch ball to pull a trailer. I have attached a great article that explains how to choose the best one for your setup, along with a link that will take you to our available selection. I have attached a couple additional articles on trailer towing that you might also find helpful.

expert reply by: Chris R

0