Replacement Regulator For a Coleman Pop Up Camper

Question

Question:

I have a Coleman popup camper that has a regular with two outputs. My understanding is one is at 16wc for the hi-pressure stove and the other is at 11wc for everything else. I dont see anything like this on your site, but have you heard of this problem? Do you carry anything I could use to replace the leaking one on the camper?

asked by: Ben L

0

Expert Reply:

I'd be surprised if you have a line that has a pressure rating higher than 11 inch water column as that's the standard for camper applications. If you are looking for a new regulator the MB Sturgis Regulator part # 108221 is a great solution to replace it.

expert reply by: Jameson C

0

Tom

7/27/2024

There is in fact a second regulator that is 12 PSI which is dedicated for the coleman stove which is a higher pressure. Coleman stoves use their own regulators. It usually looks like a short pipe that connects to a 1 lb propane canister.

Reply

Answer 1

The Camco Regulator Cover for Dual Stage Regulators part #CAM59344 is a universal fit cover designed to fit standard regulators and will work great on the MB Sturgis Horizontal Regulator part #108221 that you mentioned.

view full answer...

Answer 2

The MB Sturgis Horizontal 2-Stage Propane Regulator #108221 that you referenced does not come with a bracket. I wish we offered one but we do not as most applications already have a bracket for the regulator and this is designed to fit standard…

view full answer...

Answer 3

The MB Sturgis Horizontal 2-Stage Propane Regulator part #108221 and the Camco Horizontal 2-Stage Propane Regulator part #CAM59323 are both horizontal mount two stage regulators. You will not have any problems using either of them on your 2015…

view full answer...

Answer 4

The overall length of the #108221 regulator is 6.38 inches, at its widest it's 2.91 inches and 2.40 inches at its tallest, as you can see in the provided diagram I obtained from my MB Sturgis Representative. You can click the link to view a…

view full answer...

Answer 5

Both single-stage #CAM59013 and dual-stage #108221 regulators will both reduce pressure down to 11" WC, but the difference is the stability of the output pressure. The single-stage regulators quickly reduce the pressure down and give you a bit…

view full answer...

Answer 6

What you are describing does sound like a regulator failure, and that isn't too surprising due to it being 11 years old. RV regulators have a lifespan of about 10 to 15 years, and that's the time frame in which they should be replaced. You…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 12

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Replacement Regulator For a Coleman Pop Up Camper

Product Page this Question was Asked From

Continue Researching