Installation Location of Valterra No-Fuss Flush

Question

Question:

Where is the best place to install my valterra no fuss flush so it cleans the tank and sensors the best?

asked by: Peter M

0

Expert Reply:

When installing the Valterra No-Fuss Flush with Check Valve # A70 to your RV, you will want to drill the 1 inch hole that the No-Fuss Flush will install in at a location about 2 inches from the top of the tank, as near center as possible. This will be the ideal location for the jet stream spray that will remove and flush away tank deposit.

I have also attached a short demonstration video on this product for you to check out.

expert reply by: Chris R

0

Answer 1

I spoke with my contact at Valterra and she informed me that the part #A70 would not leak for you and it has no moving parts. I attached a set of install instructions for this product that she sent me as well for you to check out.

view full answer...

Answer 2

There is a difference between a 7-way round and and 7-way rv blade connector. If you take a look at the accompanying photo, which is from our linked article on trailer wiring you can see that the connector on the left has blade-style pins while the…

view full answer...

Answer 3

The most common way is to use bleach on fresh water tank, about 1/4 cup per 15 gallons and dump into an open container after flushing the system. If you have one of those kids pools, that would be perfect. Bleach rapidly degrades in the presence of…

view full answer...

Answer 4

I do have replacement parts for your 2021 Forest River Salem FSX Travel Trailer. You will have lots of options. There are different cutout diameters and flange diameters for your city water connection inlet. If your cutout diameter is 1-1/2",…

view full answer...

Answer 5

To use the Valterra Sensor Cleaner part #V22011 on either a gray or black tank you will need to add 8 oz (half the bottle) to an empty tank and then fill tank with water. After 24 hours you can empty the tank at your convenience. It's recommended…

view full answer...

Answer 6

I believe I have a solution for you. What you can do is use the LaSalle Bristol Toilet Floor Flange w/ Spigot for RV #3446336347 with the Valterra DWV Adapter for RV Sewer System - ABS Plastic #D50-2929. The #3446336347 is 1-1/2" tall but when…

view full answer...

Answer 7

In order to help prevent leaking between the grommet and tank on the Replacement Rubber Grommet for RV Black Water Tanks part #F02-2106 it would be wise to use a sealant like part #LT37467 between the two surfaces. I am not sure if this is a…

view full answer...

Answer 8

While I do not have a video demonstrating how to install or remove the idler head and drive head cover for the Lippert Edge Awnings, it is a pretty simple process. You will need to extend the awning out far enough to get access to behind the cover,…

view full answer...

Installation Location of Valterra No-Fuss Flush

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching