Carpet Product Suitable for Lining Fender Wells of Enclosed Trailer
Updated 04/18/2017 | Published 04/17/2017
Products Featured in This Question
Question:
If i give you dimensions can you set me up with a carpet kit /trim etc for just my fender wells on my enclosed trailer? Might do walls later but just want to get the fenders covered for now. They are 6.5inch on top 8.750 tall and 102inch long They have L trim along the top only from the factory. thanks.
asked by: Rusty K
Expert Reply:
We do not custom-make any products here at etrailer but we do have CE Smith Deluxe Marine-Grade Carpeting # CE11330 which comes in a 12-foot roll that is 11-inches wide. This item is very close to your required dimensions so two rolls should get you covered (sorry, couldn't resist). We also offer this in charcoal grey # CE11372.
Product Page this Question was Asked From
Pollak Circuit Breaker - Cycling/Automatic Reset - 30 Amp - Straight Mount Bracket
- Accessories and Parts
- Wiring
- Circuit Breaker
- 30 Amp
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Hitch, Wiring, and Brake Controller for 1997 K3500 Dually
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Electric A-Frame Jack for 2019 Jayco SLX 212QB
- Q&A: What Bolt Pattern Wheel Does Phoenix USA Rear Wheel Center Cap Fit
- Q&A: Towing a Trailer with Electric Brakes with a Semi Tractor with Air Brakes
- Article: Thank you!
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What Gauge Wire Is Required On a 7-Way Connector
- Q&A: Replacement Winch Control Box for DK2 Avalanche
- Q&A: How To Install The Go Power Industrial Pure Sine Wave Inverter Charger
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Best Bike Racks for Electric Bikes