Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The exact replacement hub assemblies you need for your BD2-545-17 are the etrailer Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 #AKHD-545-35-K that you referenced.
view full answer...The Optronics LED Trailer License Plate Light with Bracket #OPT97FR would normally be mounted to the surface of a trailer. The the only way to power this light using the Curt Auxiliary LED Indicator Lights #C53201 would be to splice into the running…
view full answer...If you look on the frame of your trailer there should be a plate with the trailer VIN number and the axle capacities of the trailer. You will want to pick leaf springs that are as close to the axle capacity as possible. You will want to also measure…
view full answer...Since you can be looking at a max weight capacity of 14K you need a tire rated for at least 3.5K so that it can accommodate up to that weight. For your application I recommend using the Kenda Karrier ST235/85R16 Radial Trailer Tire #AM10295 because…
view full answer...From the information that I was able to find on the L44549 bearing, it shows it being a 1-1/16 inch bearing which is the same as Trailer Hub Bearing, #L44649. Just to be sure, I recommend measuring the L44549 bearing with a digital caliper to confirm…
view full answer...It sounds like the axles were attached with 2 inch U-bolts that are 1/2 inch diameter which are a standard size so it sounds like the axles are compatible with a standard U-bolt kit like the CE Smith U-Bolt Kit for Mounting 2" Square Trailer…
view full answer...The dimension you inquired about is shown on the linked diagram. The spindle-center to frame mounting point on the Timbren axle-less suspension system #A20RS545 is 2-5/8-inches. If you wish you can see various other dimensional drawings on the…
view full answer...Yes, the Solera 13.5' Slider (Slide-Topper) in White w/ White Hardware #LCV000163300 is a confirmed fit for trailers with slide-out boxes 152 to 157-3/4 inches from outside front of box including the flange. This is the awning I recommend for…
view full answer...In general shackle bolts turning from use over time does not considerably wear out components. As long as the bolts are greased normally the movement from standard use would not cause them to wear out. The tension of the bolt and nut is loose enough…
view full answer...It is possible to mount the springs on top of the axle which is called "flipping the axle". To accomplish this we normally recommend an over-under conversion however there is not one with square u-bolts available for your square axle.…
view full answer...Square axles normally don't have spring seats like a round axle but do have a hole for the leaf spring bolt to fit into. Take a look at the CE SMITH #CE33201GA-HUB for a visual. The U-bolt mounting kits will have a hole in the center for the…
view full answer...For your trailer wiring, I recommend the Submersible LED Trailer Light Kit w 25' Wiring Harness #TL16RK along with the Identification Light Kit for Trailers over 80" Wide - Submersible - 3 LEDs - Red #MCL22RK3B. I recommend the Sealed, Thin…
view full answer...Filter Your Search
Contact and Help