Installing The Tekonsha P3 Brake Controller In A 2017 Nissan Armada Using the Plug-In Wiring Adapter  

We can get your 2019 Nissan Armada with the factory tow package set up with a trailer brake controller, and since you have the tow package all you'll need is the brake controller and wiring adapter. For your '19 Armada I highly…

I do have some great brake controller options for a 2018 Infiniti QX80 but there aren't any pre-drilled holes or slots in the dash on this vehicle for this purpose. If you don't want to drill into the dash then I recommend the Curt…

Yes, to use your Redarc Tow-Pro Elite Trailer Brake Controller #RED44FR in your 2018 Infiniti QX80 you can use the Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers #RED39FR.

If you have a factory 7-way on your 2016 Infinity QX80, then you will only need the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Nissan and Infiniti #3050-P to get your Draw-Tite Activator IV Trailer Brake Controller - 1 to 4…

I would contact your Infiniti dealer to make sure your hitch is rated for weight distribution, but since it is a class III hitch most likely it is. Curt does makes a class III trailer hitch for the 2014 Infiniti QX60 that is rated for weight…

We do carry wiring pigtails for Tekonsha prodigy trailer Brake Controllers that will work on your 2014 Infiniti QX80. I have attached a link to a help article that explains installation of a brake controller. If you are looking for just the pigtail…

The Firestone Coil-Rite Air Helper Springs - Rear Axle #F4164 is compatible with all models of the 2016 infinity QX80. The Air Lift Load Controller Compressor System for Air Helper Springs- Heavy Duty - Single Path #AL25854 is also my recommendation…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…