Custom Fit 2017 Chevrolet Silverado 3500 Accessories

Hello Ross, thanks for reaching out. Yes, the Yakima Tonneau Cover Adapter Kit #Y01155 will work together with the TS Rails for TruXedo Elevate Rack System #TH65FR. We have actually had a few customers report back to us that these parts do work…

Hello Ross, thanks for reaching out. For the etrailer Swivel Jack w/ Bolt-On Mounting Plate #e22ZV the distance from the bottom of the pipe mount bracket to the bottom of the jack when fully retracted is 8". I edited a picture to illustrate. Let…

Between the two kits you mentioned the Equal-i-zer part #EQ37120ET is the best choice. This is the highest quality option out there for a weight distribution system and is what Curt tried to emulate with their TruTrack part #C17501. The Curt kit is…

Hey Steve, is the height from the bottom of the mounting plate? If so, then I think the Fulton #FTJ120W0301 would work for what you are looking for as it has the shorter height below the mount and has a wheel caster.

Hey Gary, how many axles does your trailer have and by how much would you like to lift the trailer? A lift kit like the Correct Track part #RR23QX for a 1 inch lift or the part #RR55QX for a 2 inch lift on a tandem is normally what we recommend.

Hey Jeffrey, thanks for reaching out! The etrailer Electric Trailer Jack #e55ZV does not require an additional fuse/relay as it has an auto-reset on built-in, and the outer diameter of the jack tube is 2-1/2". Are you looking to replace an older…

Hey Connor, when the etrailer jack #e22ZV is retracted the overall height of the jack measures 17-3/4 inches.

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

Hello Johnny, thanks for reaching out. The etrailer Electric Trailer Jack #e55ZV runs off 12v power. The jack has 2 wires so red is positive and black is negative. It is intended to be wired directly to a trailer battery. You could attach the wires…

You could do either one! The etrailer Electric Trailer Jack item #e55ZV can be wired to the accessory circuit through your trailer's 7-way connector or you can connect it directly to your trailer's battery. The accessory circuit is typically…

No, you would not be able to install an aftermarket gooseneck hitch like the #BWGNRK1108 on a truck that already has the factory puck system. Parts of the puck system would obstruct both the frame brackets and crossmembers of the gooseneck hitch. The…

The shipping weight of the MORryde Cushioned 5th Wheel Pin Box for 14K to 18K Trailers with Lippert Rhino part #MR83QR is 165 lbs.