Hello Donald, thanks for reaching out. The RAS kit for the 2016 Toyota Tundra part #RAS34FR will help with overall stability and will help reduce sagging. It may not take care of 100% of the sagging, but will definitely make a notifiable difference…
The HappiJac Truck-Mounted Camper Tie-Downs Item #LC184089 is not a confirmed fit for your 2010 Toyota Tundra because the frame is different and bends in the plates are different on the 5-1/2' beds versus the 6-1/2' and 8' beds. The…
I really like the Firestone airbags because they use a crimp rolled design which is much more durable than the band clamp used with the Air Lift Kit item #AL88299 you were looking at. For your 2016 Toyota Tundra, I recommend the Firestone Ride-Rite…
Hey Ruby, thanks for reaching out! To replace the cover only on your Pace Edwards Switchblade on your 2018 Ford F-150 you need one of the following: - Replacement Fabric Panel with Latch #PE87AJ - Replacement Fabric Panel without #PE27AJ
Fulton's snap-ring jacks like the #FTJ120W0301 are going to top out at 1,200lbs and the 1,500LB Jack #F141132 you found has a bolt-thru design and is not offered in a snap ring. We do offer the 2,000LB Jack #TJB-2002S-B which would fit your…
You will need to measure the diameter of the spindles where the seal and bearings ride. Check out the picture I attached that shows where this is. You will need an exact measurement so either a digital or dial caliper will be needed. To pick out the…
When you set up a set of guide ons like the part #CE27660 you wouldn't want them to contact both sides of the boat at the same time. You would want an inch or two of clearance between the boat and the uprights.
The difference between the letter D in your ST175/80D13 and the R in the tire size of the Wheel and Tire ST175/80R13 part #AM31985 that you referenced is the tire construction. D stands for bias-ply which is a less preferred tire construction,…
When it comes to picking out a 14,000 pound weight distribution system with a 2-1/2 inch shank, I recommend The Equal-i-zer Weight Distribution System w/ 4-Point Sway Control - 16,000 pounds GTW, 1,600 pounds TW #EQ64FR. This weight distribution…
Hey Rick, no the Replacement Cover for Pace Edwards JackRabbit Hard Tonneau Cover #PE48UV you're looking at is not going to work with your 2014 Ford F-150. Assuming you have a 6 1/2' bed, the correct cover for the Pace Edwards JackRabbit…
The short answer to both of your questions is yes. You can remove the backing plate or brake assembly and use the existing hub with integrated drum by itself, or, you can simply replace it with an idler hub. Based on the photos, I would suggest…
I do have a suggestion, because we have a gas strut with with dimensions that are the same as the Stabilus 654150 which is likely to work; the Stabilus strut measures 26.46" when extended with 120 lbs of force. The nearly identical strut we…
