Custom Fit 2014 Chrysler Town and Country Accessories

It really depends on your setup, if the safety chain loops on your tow vehicle are spaced far apart then you will need more slack to make a tight turn then if they were closer together. What I would recommend you do is connect your trailer to your…

The attached video for a 2014 Dodge Grand Caravan shows where the locations are on the underside that need to be removed. These are installed at the factory, and should all be in the same locations as shown in the video. This hitch comes with…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Timbrens like the #T28MR that you referenced are not known to make a huge difference with trailer sway. If you are experiencing trailer sway most likely it's due to improper trailer loading which you can fix by moving forward any cargo weight in…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

For your 2014 Chrysler Town and Country, the first thing you are going to need is a trailer hitch and I recommend the etrailer Trailer Hitch #e98854. For wiring which will give you a 4-way connector and allow you to power your trailer's lights…

I spoke to my contact at Timbren about the Timbren Rear Suspension Enhancement System part #TFR250SDG for your 2012 Ford F-250 and they informed me that the upper metal bracket cannot be removed. Therefore, the bump stop cannot be directly attached…

It is possible that the Curt 4-way connector like the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C62VR can short out. This is usually caused by a short in the trailer wiring. You can test your harness by using a…

Unfortunately there is not a compatible ramp or adapter that will work with your Thule T2 Pro XTR Bike Rack for 2 Bikes - 2" Hitches #TH83JV. If you're needing a ramp your best bet apart from fabricating your own is to use the Thule EasyFold…

Hey Bob, There is indeed a loading ramp from Thule that will work with any of the Epos bike racks - the Thule Epos 3-Bike Rack #TH69XE, Thule Epos 2-Bike Rack w/ LED Lights #TH49XE, and Thule Epos 2-Bike Rack #TH99XE. I went ahead and verified for…

Thank you so much for the info and pictures! The correct replacement key for your lock for is part #THKEYN2982 and the correct replacement mounting hardware is part #TH05603. The mounting hardware does look a little different than the original…

To replace the mounting hardware on your Thule Cascade cargo box, you will need the Thule quick mount hardware #TH04997. This won't be the original U-bolts, but it will work in the same way. I've attached a photo that shows how it works.