Videos
for Toyota Matrix Owners
Help Articles
for Toyota Matrix Owners
Expert Answers
for Toyota Matrix Owners
Rusty weld nuts can make trailer hitch installs pretty difficult but there are solutions. First you want to clean them as well as possible so that hopefully that allows the bolts to thread. But worst case scenario you can use a thread tap to clean…
view full answer...There are both Class I and Class III trailer hitches available that are confirmed to fit your 2010 Honda CR-V. The available Class I hitches, such as the Draw-Tite Sport Frame #24792, feature a square tube design, while the Class III hitches like the…
view full answer...It sounds to me like the hinge pin on your trailer's tailgate is worn and is causing excessive movement which will result in a noisy ride. In order to secure the tailgate to the trailer while driving down the road I recommend using a set of…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...Some newer cars, vans and small trucks, especially those with large, aftermarket tires, may require the use of Class S chains. Class S tire chains are designed for use on vehicles with restricted wheel well clearance. I have attached a photo that…
view full answer...Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…
view full answer...That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…
view full answer...Thanks for reaching out Seth. I did some digging on this and it looks like GM doesn't recommend using tire chains with your specific tire size. The main concern is the limited clearance behind the tires, where chains could potentially contact and…
view full answer...






















