Comprehensive Review: Spring-Eye Bolt with Locknut for Slipper Springs Video

Hey Joe, thanks for the information! To replace your Dexter 072-079-01 leaf springs, I recommend the 7-Leaf Double-Eye Spring for 8,000-lb Trailer Axles item #EM28AJ. This is a 4,000 lbs leaf spring designed for 8,000 lbs axles. It's got 7-leafs…

Hi Gary, I completely understand wanting to be certain before making the switch to lithium. Yes, I can confirm that the Progressive Dynamics 9300 Series RV Converter Charger, Part #PD79RR, is compatible with LiFePO4 batteries, including the LiTime…

The Spring-Eye Bolt with Locknut for Slipper Springs #166079 is a total of 3-3/4" long. The measurement from the back of the head to the start of the threads is 2-3/4" and the length of the threads are 3/4".

Hey Jon, thanks for reaching out. There are a few ways to find out what bearings you need. The easiest way is to take a look at your hub and see if there is a part number cast on the front or back. Usually we can use this number to pull up your…

Hi Don, While we don't have a way of knowing what leaf spring bushings are on any specific trailer and don't have any type of database for a VIN, it's pretty easy to find the bushings you need. Just measure the diameter of the bolt hole…

For the axle U-bolts, we have two different options: - 3" Round Trailer U-Bolts 9/16" Diameter #SP01-080 - 3" Round Trailer U-Bolts - 1/2" diameter #SP01-060 Since these bolts are so close in diameter, I recommend measuring the…

The TruRyde #TREQ1344 Equalizer for 2 inch wide Slipper Springs that you referenced is considered a fit for the dimensions that you listed on your triple axle trailer with seven thousand pound axles. I would recommend replacing the entire equalizer…

When installing suspension components on your trailer there is not going to be a torque setting for the hanger bolts because they really only get tightened down to hand-tight. Going more than hand-tight can pinch the hangers closed and prevent the…

The Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black #LC285318 has a drop leg available that will give an extra 4-1/2 inches with #LC405217.

Slipper Springs like #e33SR do not use a bolt and bushing for the open eye end of the spring. It connects directly to the hanger using a slipper spring hanger kit.

Hey, Kevin. I'm not 100% sure what you mean by better but we do have double lip seals that will work for you. Part #RG06-010 match up to the 1.250" inner and 1.979" outer diameter that you are needing. The thickness of the seal…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…