Complete Breakdown of the Reese Pro Round Bar Weight Distribution w/ Sway Control Video

Hey Tom! Great question. The Parkit360 Force Electric Trailer Dolly #PA96VR (5,000 lbs) and #PA46VR (10,000 lbs) will work on an incline. However, if the grade is more than 6% you cannot use the dolly. As long as your driveway is no more than a 6%…

Hello again, Phil. Out of those two options I definitely recommend the Reese Dual Cam II #RP65FR with the no-drill frame brackets. In my experience, any WD system that uses no-drill L-brackets that bolt to the frame is going to be much easier to set…

Hey good question, Adam. There is not a specific limit on how many spacers you can use with Timbrens. Most trucks that use Timbrens would not be lifted more than 4"-6" anyway, and I have heard of people using up to 6 spacers on each side. I…

Nicki, that is an excellent question that we've gotten before. The Andersen weight distribution hitches work in a totally different way from competitors which allows it to remain lightweight, not bulky, and easy to install or remove. The chains…

Hey there Layla! There are a few different forms of weight distribution hitches, but the majority of the systems that have sway control use friction bars, which work similar to brake pads on your vehicle. This works really well, but it can sometimes…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

That's a really great question! While I don't have a direct answer for you since there are some variables in play, I can give you some information that will help you figure out is the 1,000 lb tongue weight (TW) #BXW1000 or the 1,500 lb TW…

It sounds like you are looking for the socket required to install the nut on a 2-5/16" hitch ball like the Curt #C40030 you were looking at. You will need a 1-7/8" socket like the 1-7/8" 12pt Thin Walled Socket - 3/4" Drive -…

Yes, I went out into our warehouse to measure the nut of the Trailer Hitch Ball #C40030 and found that a 1-7/8 inch wrench would be the correct size. The same size wrench would be used for the top portion of the ball as well.

The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached…

The Curt TruTrack Weight Distribution System part #C17499 is what I recommend for a 2021 Jayco Jay Feather X23B. It has integrated sway control for stability, built-in zerk fittings for ease maintenance, and a simple no-drill design. It also comes…

Just like the propane/electric models, in order for the liquid refrigerant to flow throughout the unit properly, the EverChill Refrigerator #324-000119 will need to be mounted within 3 degrees off level side to side and 6 degrees off level front to…