Breaking Down the Fusion LED Trailer Tail Light Video

On each individual electric brake magnet the amperage draw would be 3.0 to 3.2 max amps at 12 to 13 volts on 7-inch brake magnets and 3.2 to 4.0 max amps at 12 to 13 volts on 10 and 12-inch brake magnets. The max amperage draw for the brake magnets…

There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…

You should be able to use the same size clip as the inner diameter of the wire loom. For example, the 3/8" Diameter Wire Loom #39035 has grooves in it that would allow you to use a 3/8" inner diameter clamp. Same thing goes for the…

Great question Chad, and I’m glad you’re checking before wiring everything up so it works correctly the first time and you don’t run into any issues on the road. For the Fusion LED tail light part #OPT37FR, it uses a standard combined stop and turn…

You can cut off the old spindle and have an EZ-Lube spindle welded on your current axle. I would recommend using the same size spindle, just the EZ-Lube version, as your trailer originally came with. That being said, new hub assemblies and bearings…

The difference between the standard and EZ hubs is in the grease cap. For instance, the Trailer Hub and Drum Assembly - 3,500-lb E-Z Lube Axles #AKHD-545-35-EZ-K is the same hub, bearings, seal, and races as found in #AKHD-545-35-K but the grease cap…

Hey James, Can you doublecheck the measurements of your spindle at points B, C, and D from the diagram below with a caliper #PTW80157? If the spindle is tapered the inner and outer bearings should be different. The only grease seal that matches your…

Hello Mike. It sounds like you are wanting to add electric brakes to your boat trailer that currently has no brakes. This is possible, but you will first need to make sure that your axle is equipped with a brake flange at the base of the spindle. The…

Hey Darren, the studs of the Optronics Fusion LED Trailer Light #OPT45KB that you referenced are not designed to thread out of the assembly easily. You could take a cutting wheel to them and cut them off flush pretty easily though if you wanted to…

Yes we do Danny, check out the Optronics LED Trailer Tail Light #STL78RPG. This is a submersible LED tail light that has 10 diodes, a 3 wire design, and measures 7-9/16" long x 3-5/16" tall x 3/4" thick.

You'll want to connect the black wire to a switch or circuit you can turn on and off for the Red Identification Light Bar with White LED Utility Light item #OPT88FR. If you wire it up like a standard light to a tail light wire the white utility…

Hey Sal, the Optronics Fusion LED Trailer Light #OPT45KB is for just 1, not set of 2. These are super nice, but if you want some other options to consider, we also have the Fusion LED Hardwired Trailer Light #OPT57NR which does have the same…