Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
I contacted Trimark in regards to a replacement part for the Trimark 030-0900. 030-0900 is actually a series number not a specific part number. To find the part number you will need to take the interior handle completely off the unit. On the back…
view full answer...If your current rotary lock is same dimensions as the Bauer Products Rotary Latch part #BA85FR this would be a great solution that would work well. This has cut out dimension requirements of 6" tall x 4" wide and is a nicer latch…
view full answer...Thank you for the picture. That kayak carrying device certainly does look cumbersome. Quite the interesting contraption. While generally we do not recommend modifying products like this, but I am happy to help if I can. With the bar being only…
view full answer...A Dexter 8k axle is going to have a hub installed on it that has an 8 on 6-1/2 inch bolt pattern. I attached a page that has all of the 17.5-inch rims we offer with this bolt pattern for you to check out. The most popular wheel is the part #TA35ZR…
view full answer...There are two schools of thought when it comes to determining the correct sized winch for a boat. The first being that the winch should be able to handle 3/4th of the total combined weight of the boat along with the motor, fuel and gear. The second…
view full answer...You are correct that the issue is on your trailer and based on what you are describing the circuits are somehow swapped when you installed your connector; unfortunately, I was unable to find your order number to see what you purchased from us for the…
view full answer...Your problem is in the wiring in one of two places. It is either on the vehicle wiring harness or somewhere in the wiring on the trailer. The first thing to do would be to narrow it down to one of these two places, then we can pin-point the problem…
view full answer...While we do have some great U.S.A.-made boat trailer jacks, the etrailer Round Swivel Marine Jack #MJ-1500B-DWL is manufactured in China. However, for a super close U.S.A.-made model, I recommend the Dutton-Lainson Swivel Marine Jack #DL67MR. This…
view full answer...There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…
view full answer...The replacement parts we have for the Bulldog Square Jack #BD182500 are a Replacement Gear Kit #BD500212 and a Replacement Screw and Nut Kit #BD500217. These are the two most likely aspects of the jack to be causing your problem. I have attached the…
view full answer...The SuperWinch LT2000 Electric Utility Winch, part #1120210, you have referenced will only have a rated line pull of 2,000 lbs. The rated line pull of 2,000 lbs. will pull a rolling load of 10,050 lbs. up a 6 degree incline, but as the incline…
view full answer...I do have a possible option for you but the Replacement Drop Leg for etrailer and Ram Square Direct Weld Jacks - 3K #TJD-5000-FT only has a capacity of 3,000 lbs so that wouldn't be enough for your dump trailer. The possible option I have is the…
view full answer...Filter Your Search
Contact and Help