Result: solenoid

Hey Ron! Sorry to hear that happened. Have you asked them to replace it? The Mighty Cord Replacement RV Power Inlet #A10-30INBKVP door isn't available separately but it can be replaced. You can remove the four screws from the cover which will…

Hello Al, Happy to get those for you. I would want to take a gander at them too, just to see what I’m getting myself into. I was able to get the instructions for the Advent Air Low Profile RV Air Conditioner System, Single Zone, 15,000 Btu, White,…

It sounds like you installed the Demco Hydraulic Brake Kit #23511-10 correctly but it is possible you may have adjusted them a bit too aggressively, as "slight drag" is subjective, of course. Otherwise there could be an issue with your drum…

Hello Brandon, thanks for reaching out. The Replacement Left/Curb Side Leg for etrailer and Ram Hydraulic Jack #e63VV is intended to be used with the #e43VV power unit and #e73VV. The legs are designed to be used in tandem, but they can be used for…

The Lippert 171317 steps you've currently got have been discontinued, but you can use the Kwikee 32 Series Electric RV Steps - Double - 7" Rise - 22" x 8" Bolt Pattern #LC372261, which according to Lippert would be a direct…

The Replacement Control Unit for Kwikee Electric RV Steps #LC379146 which is part 90950600 you referenced is does not have a specific wiring diagram, but I've attached the closest thing and have also included a video of an installation to…

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack #LC298707.

You will need to cut that off of your 2001 Cobalt 240 to replace the actuator since there are no replacements that will fit. I recommend welding on a straight tongue so you can use a bolt-on actuator like the Dexter Zinc-Plated Brake Actuator…

For a Lippert 4,400 lb trailer axle the correct bearing kit is the part #BK2-100 which includes inner bearing #L68149, inner race #L68111, outer bearing #L44649, outer race #L44610, grease seal #58846, a cotter pin and a tang washer.

Typically, when the outside edges of a tire are showing wear its because the tires are under-inflated. The solution is to inflate the tires to the maximum pressure listed on the sidewall. Now if the outside of tires have what looks like gouges are…

I've attached a picture with three different measurements for the B&W Extend-A-Goose Gooseneck Coupler - 2-5/16" Ball - 10" Offset, #BWTEXA4200. It is 12 inches from the base or bottom of the coupler to the center of the lowest pin…

Yes, you are absolutely correct. In order to use the Thule Mounted top Rack System #THTB60 or #THTP54 with the WingBar Evo Crossbars #TH711220, you will need the following parts: - Rapid Podium Feet for Thule Crossbars - Fixed Point #TH460R - Fit Kit…