Yes. You can use the LED RV Utility Light #DG52643 with an LED compatible dimmer switch like the LED Dimmer Rocker Switch #37215205 (white) or #37212275 (black). You will need to make sure that any dimmer switch you decide to use is designed…
I have to agree with you that it sounds like something is wrong with your Lippert powered tongue jack since the courtesy light should go off completely when the switch is in the off position. I suspect that there is trapped water inside the switch…
We do have a wiring diagram for the Lippert Components Kwikee Step Rocker Switch #LC371010. I have attached a clip from the installation instructions that demonstrates how to wire this for you to check out.
It sure can Ken. The PowerMax 30A RV Power Center and Distribution Panel item #PM67VR is designed to accept a standard 120VAC, 30 Amp input, which is what you'll get with shore power provided by most generators. This power center has a 55 amp…
The Lippert 15-Foot LED Fabric Light Kit for Solera RV Awnings #LC674282 is intended to install by sliding into the light cord by the coach sidewall, under the awning, that is sewn into the awning fabric. If you prefer an LED light strip that…
The Replacement Control Unit for Kwikee Electric RV Steps #LC379146 which is part 90950600 you referenced is does not have a specific wiring diagram, but I've attached the closest thing and have also included a video of an installation to…
The 2" x 10" measurement that is mentioned for the JR Products Undampered RV Floor Register #37202-28935 has to do with the typical size of the opening that it fits into. Since the flange itself measures 3-3/4" x 11-1/2" it will…
We currently only offer a 2" piano hinge with a 1/4" diameter pin in a 72" length so you would need to purchase two and cut one down to cover the rest of the 83-1/2" of length you're needing.
I am attaching a wiring diagram for the Replacement Single-Panel On/Off Switch for Atwood Gas and Electric Water Heaters #AT91959 that you can reference.
It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…
Filters
