Result: L44610

Good question Lee. Most people don't think about fluid compatibility, but it's important. Demco actuators like the DA75 Trailer Brake Actuator - Zinc - Disc #DM33CV are technically compatible with DOT 5 fluid, but only when it's new. It…

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

If the inner diameter is 1.719 inches and the outer diameter is 2.565 the #RG06-050 would be the closest matching grease seal we offer. You will need a digital or dial caliper for this measurement. The grease seal number you referenced doesn't…

Hey Rick, thanks for reaching out. The #BK2-100 bearing kit is correct for your 3,500 lb axle with #84 spindle. Spindle sleeves are not included but we do have them available separately as part #BB60010 (1 pair). For that you'd need a 1-1/2"…

Hey Barry, it sounds like you're looking for the Dexter Electric Trailer Brakes #K23-472-473-00. These are Dexter brakes that measure 10" diameter x 1-1/2" wide, and are designed for 3,000 lb axles.

Hey Mike, we do have a replacement hub/drum that works with the 3k rated Dexter brake assemblies part #K23-472-00 with the part #DX62KR.

The UFP hub that you've referenced isn't made any longer I don't believe, but we do have some options for you. From some previous customers, we've determined that the UFP H-1062-3 axle has a spindle that has #L44649 inner and outer…

From the numbers you provided it sounds like you need replacement grease seals. In my research, the grease seals I found with the GS-1719DL number have a 1.72 inside diameter and 2.565 outside diameter. The replacement double lip grease seals you…

The 171255UC seal is the same as the Dexter 010-11088/K71-G01-80. We have that same seal available as the Grease Seal Kit- Triple Lip - Inner Diameter 1.719" - Outer Diameter: 2.565" - Qty 2 #DX49CR.

Just because the Timbren Axle-Less Trailer Suspension System #ASR1THDS02 has brake mounting flanges does not mean you have to run hub/drums on them. You can install idler hubs on the spindles just fine. For an idler hub that would fit the spindles…

We do have one axle with hubs that is extremely close to the dimensions you have requested. It is the CE Smith Trailer Axle w/ Idler Hubs item #CE33201GA-HUB. It measures 57-1/2" long, has a 46-1/2" spring center, and an 1,800 lbs capacity.…

A replacement tang-style spindle washer like part #5-101 is intended to be installed behind the castle nut and have its prongs bent down so that they prevent the castle nut from rotating on an E-Z Lube type spindle. The castle nut holds the washer in…