Result: 134543

While it is possible to replace just the magnet like part #Replacement Magnet Kit for 12" Electric Trailer Brake Assemblies part #AKBRKR-M12 I highly recommend replacing the entire assembly. It proves very cost effective and can save you labor…

Hey Robert, I found the hub you mentioned and it's actually not a Lippert hub it's made by AP and it's a 7k axle hub with a 9/16 inch diameter wheel stud. The drive in wheel stud part #7-132 could work for you since it is a 9/16 inch stud…

Hey Feb, no there isn't a rebuild kit for the Replacement Jack part #LC362485. If yours is damaged only solution would be a replacement

Hey Donald. The Dexter 072-032-00 is a 26-1/2" long slipper spring, with a hook end, 5-leafs, that works with a 7,000 lbs axle. Our closest option to replacing this spring is the 5-Leaf Slipper Spring for 7,000-lb Trailer Axles - 26-1/2"…

According to Dexter, this is a 3,750 lb torsion axle with a 90.3" hub face measurement. More than likely your axle uses #L68149 and #L44649 bearings with a #168255TB grease seal. You will need to verify this information since Dexter did not have…

I was able to determine your 3,700lb UFP torsion axles should have a hub face of 89" and the bracket spread is 72". While we do not carry torsion axle we do have the Timbren Silent Ride Suspension for Tandem Axle Trailers #TSR7000T04 which…

The Replacement Standard Dual Rack Repair Kit for Lippert RV In-Wall Slide-Outs - Fixed Side, #LC84FR is the left side of the slide-out as looking at it, facing it, from the outside. The float side, #LC26VR, will of course be the right side as facing…

The Curt Custom Tail Light Wiring Kit for Towed Vehicles #C96JR can be used with your LEDs, the only caveat is that if your Jeep has ParkSense proximity sensors then you'd need to use the Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles…

According to B&W the B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit part #BWGNRK1020 is about a 2 hour install by a professional. All the Hardware is provided. I have attached the installation instructions so you…

I called Dexter and they told me that your Dexter P-12 SLR SN: D5287869 axle has a 3,000 lb weight capacity. If you need any parts please let me know what they are and I would be happy to offer my recommendation.

Thank you for the picture! I gave my contact at Dexter Axle the serial number off of your tag and he said that the replacement brakes for your #12 torsion axle include part #23-180 for the left hand side and part #23-181 for the right hand side. If…

Assuming your tires are in good shape without any bulges the easiest way to determine if you have a bent spindle is to take a straight edge that is longer than the tire and lay it across the tire parallel with your trailer frame and then measure the…