Location of Fill Ports on Valterra RV Water Tank
How can you fill this? I don’t see a fill port. Or does it require a pressurized water supply? | Hi Elliott; the Valterra RV Water Tank # R8048 has three 3/8" threaded fittings on each end of the tank. You can see them in the attached picture,...
Recommended Tire Chains for a 2023 Rivian RS1 275/50 R22
Hello, I’m looking for low profile 16mm or smaller snow chains/cables for my 2023 Rivian RS1 275/50 R22. Would these work? Thanks! | Hey Julie, thanks for the information and the picture! I checked with Rivian and we've only got one set of tire...
Tonneau Compatible Ladder Rack For 2025 Rivian R1T With OEM Tonneau Cover
2025 R1T I am 5 4. looking for a ladder rack options the work with the Rivian Tonneau cover that rolls with the bed rail button. and the tail gate button and also the side cargo buttons. please help with information and options. | Hey Dave,...
Recommended Wiring for RedArc BCDC Charger Used for Auxiliary Battery to Power Inverter
I have the DUAL INPUT 40A IN-VEHICLE DC BATTERY CHARGER by RedArc. What else do I need to set up a dual battery syatem with solar to charge a fridge in the trunk of my SUV, a few led lights, some charging ports for phones and accessories? What...
Parts Needed to Flat Tow a 2014 Nissan Versa Note Behind an RV
I purchased a new 2014 nissan versa note intending to flat tow with my motorhome., then found a base plate had not been developed. I then was forced to by an ez tow dolly. the dolly was a night mare. Had studied the hook up and watched the video,...
Where Do You Measure From On The Trailers Coupler to Install The Pole-Tongue Adapter # EQ95-01-5950?
For the tongue pole adaptor, you mention in the video that it need to be install between 27 to 32 inches from the reveiver in the tongue. Do we mesure from the tip of the receiver or the middle, because if I mesure from the tip of the receiver...
Parts Needed to Flat Tow 2014 Nissan Versa Note
Could you send me all of the items I would need to flat tow a 2014 Nissan Versa Note? I was looking at the RM Baseplate 52357-5 direct connect, RM Sterling Tow Bar, SMI Stay in Play Duo Brake System. I dont know what kits are needed to complete...
Installation Steps For Installing That Kat's Block Heater # KH11812 In A 2012 Kia Rio 1.6L Engine
Looking for block heater 2012 Kia Rio 1.6. Engine ,manual , 5 door . Send proper part and install instructions… want to know what I’m doing befor I start | The correct block heater for your 2012 Kia Rio 1.6L engine is the Kat's Heaters Custom...
What Extra Straps Can I Use with My 2014 Nissan Versa Note?
Just ordered this for my small Nissan car top. What is the WEIGHTof this item EMPTY ? And what extra DOOR EDGE STRAPS can I use for roof side to side strapping ? I will have RhinoRack Vortex Aero crossbars. | I have a solution for you. The weight...
Will Maxtrax Mounting Brackets Fit Rivian Cargo Crossbars
Will this fit Rivian Cargo Crossbars? | Hey Philip, thanks for reaching out! The Maxtrax Mounting Brackets # MA92PR were designed around the Rhino-Rack Vortex crossbars so as long as the T-Slots for your Rivian crossbars are similar to the...
Recommended Roof Rack and Kayak Carrier for a 2014 Nissan Verse Note
Hello, I have a Nissan 2014 Versa Note with bare roof and I would like assistance with what to but to easily carry a kayak on my car roof. I guess I need both a roof rack and a kayak rack? I am lost I would appreciate if someone could help me!...
Would Thule Hullavator Work With Rivian R1S OEM Roof Rack?
Im trying to install the Thule Hullavator on a Rivian R1S. I already have the Rivian Cargo Crossbars so Id prefer to use these if possible. The Hullavator requires the crossbars to overhang and the Rivian Crossbars dont. Is there a way to stackinch...
Replacement Fender for Shorelander SLR80TAL
Looking for replacement fender options for shorelander slr80tal dual axle boat trailer. Vin 1mdavp0234a266485. Only need one fender preferably aluminum smooth finish | Hey Alan, we do have one smooth aluminum tandem axle fender setup with the...
Will Swagman Swivel and Kuat Pivot 2 Swing Away Hitch Extender Fit Below 2025 Wrangler Sport Spare
I was going to get either the swag an swivel hitch or kuat pivot v2 and place it on a jeep wrangler sport 2025. I measured fro. The hitch center line to the bottom of my spare tire and its a little over 5 inches. Will I have enough clearance...
Good morning. | Good evening, do you have a question I can help with Mohommad? |
Can The Rhino-Rack Roof Rack For Tracks Be Installed On Rivian Factory Mounting Points
Hi. I have a 2022 Rivian R1T Will the RhinoRack crossbars work for my factory bed top edge attachment points? Thanks, Nick | Hey Nick, The Rhino-Rack Roof Rack for Thule and Yakima Tracks # Y01-140B-NT uses an M6 24x24x4 Nut to mount into...
What is your return policy? My fiancée is driving through Colorado where she legally has to have them, but may end up not using them at all. Would it possible to return them if they arent used? Thanks! | Hey Conner, thanks for reaching out! I'm...
Everchill RV Refrigerator w/ Freezer part # 324-000119 Compared to the Everchill WD-282FWDC
What is the difference between the 10cf model on your website and the 10.7 cf model WD-282FWDC I see on other sites online? | The Everchill RV Refrigerator w/ Freezer part # 324-000119 is the replacement for the WD-282FWDC you see listed on...
Will Adarac Aluminum Series Custom Truck Bed Ladder Rack Match 2022 Rivian R1T Roof Rack Height
I have a 2022 Rivian R1T. Does your rack height by chance match the factory rack height on the cab in case I wanted to use both? Thanks! | Hi Allen; I'm not sure what the factory roof rack height is on your 2022 Rivian R1T, but I can tell you...
Will etrailer Spare Carrier # e98ZR Work with Rivian R1S 20
Does this fit a rivian r1s 20 inch all terrain tire? 275 / 65 / R20 | Hey John, yes the etrailer spare tire mount part # e98ZR that you referenced will work with the wheel and tire Rivian R1S 20 inch all terrain tire that you referenced. |
Is There a Way to Adapt Yakima Raptor Bike Rack to Crossbars with Channels
Hello, I have a pair of the Yakima Raptor bike carriers and Id like to mount these on the factory cross bars on my Rivian R1T. The bar size and shape dont seem to be compatible with the universal mighty mount. So Im thinking I can use the tslot...
Ladder Rack that Fits 2025 Rivian R1t
Does it fit on a 2025 Rivian R1T, and how is it installed with a tonneau cover? Any drilling involved? | Hey Tammy, we don't have any tonneau covers for your 2025 Rivian R1T that have the needed channels to use the Truxedo Elevate Ladder Rack...
How Does Adarac Aluminum Series Ladder Rack A33VA Fit with Tonneau Cover
Hi, I own a 2022 Rivian R1T, with a power tonneau cover. After reading your materials, Im still not 100 sure of how the Ladder Rack mounts to the truck bed? Im seeing no drilling is needed great!, but wasnt totally sure if the tonneau cover...
Will etrailer Anti-Rattle Device part # e38FV Fit Rivian Hitch
Do we know if this product will work on the Rivian hitch given its hidden, and fairly deep sunken? | Hey JZ, I would have to see the hitch but basically it would need to have a lip/collar around the outside of the hitch for the etrailer anti-rattle...
Filter Your Search
Contact and Help