Result:

| For your LED Marker Light RV Side Cameras w/ Night Vision for Furrion Vision S Systems # FOS05TASF you will want to follow the wiring as provided below: RED: Connects to positive wire on running lights circuit. |

The wire harness will need to be spliced in the following manner: Red - cold side of the brake light switch Blue - brake output pin on 7-way Black - 12v power (battery) with inline fuse # 331-CBK30-EB White - ground The brake light switch wire you're looking for is coming off of the brake pedal and would be purple/white. |

White is grounded to the vehicle frame, yellow is for reverse lights, black goes to the positive battery terminal via a 40 amp circuit breaker, and blue goes to an electric brake controller. | I have a 2001...

I can't quite tell from the photos you sent in, but they'll have the following functions: Blue - 7-Way Output to Trailer Black - 12V Power White - Ground Red - COLD Side of Stop Light Switch (only gets hot when brake pedal is pressed) Are you able to test the wiring you found to see if these functions exist? |

You will need to use a circuit tester like # PTW2993 to verify the functions of the 4 wires underneath the dash of your truck, and match them to the following functions of the wiring harness on the # 90195: Black wire is 12v power White wire is ground Blue wire is brake output Red wire is cold side of stop light switch that only has power when the brake pedal is pressed Once you have identified the functions of your factory wiring you will use the butt connectors included with the # 90195 to make the connections. |

In addition you will need a circuit tester like # PTW2993 to confirm the functions of the factory wires and match the functions to the # 20160 which are as follows: Black wire is 12v power wire White wire is ground wire Blue wire is brake output wire Red wire is cold side of stop light switch wire I included a video review of the # TK63VR for you to take a look at. |

Bonus question: the Ford OEM controller by Redarc requires wiring to the center brake light, while the Curt requires just the 4 wires. | I have the 4 wire Curt universal harness pn 51515 with connectors for 12v, ground, brake...

Since the 2020 Ford Ranger has driver assist braking, tapping straight into the brake pedal switch is not recommended. The stop lamp signal is a good source since it lights up under both types of braking events (driver and vehicle generated). |

This is the cold side of the stop light switch wire. White wire from vehicle to white wire on pig tail harness. | I just installed Curt T connector 7 way wiring harness #56431. Now I need to install a trailer...

This is the cold side of the stop light switch wire. White wire from vehicle to white wire on pig tail harness. | Not equipped with a 6prong hook up for trailer. What all products do I need to hook up for tow...

These are for, respectively, the controller output, the 12V power input and the brake light switch wire. These would connect to the pigtail harness # 20127 included with the P3. | where on the ford 2019 ranger...

You pose an interesting question here, and there is no doubt that the 3-camera Furrion observation system will be perfect for the back-up/observation and side cameras: - Furrion Vision S Wireless RV Observation Camera System w/ Side Marker Light Cameras - 5" Screen # FCE48TASL-05. |