Search: echo brake controller > RV Light Fixtures > Command Electronics x >
FiltersVideos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
While we don't have replacement parts for a Model 70LP actuator, we do have a great replacement for it. Like the 70LP, these actuators are a fit for a 2" hitch ball, but they just have a slightly larger capacity at 7,500 lbs. You didn't…
view full answer...The Replacement Motor for Stromberg Carlson Electric Landing Gear Set part #LG-196308 should work in place of your Atwood 70079 Landing Gear Motor. I cannot confirm this as Atwood Landing Gear parts have been discontinued for some time so there is no…
view full answer...There is a couple things you can try to get your Husky Brute 4500 Working again. If the light are coming on and the switch is just clicking you would need to check the star washers on your ground. Remove the ground wire from the frame and scrape the…
view full answer...Since you have already tested the switch and found it to be defective it will need to be replaced. The original part is no longer available, but could potentially be sourced through an electonics supply store. If the jack has more problems and must…
view full answer...The pin that you will need to enter to pair the Curt Echo Wireless Trailer Brake Controller part #C51180 with the mobile app is located in two places, on the underside of the lid and on the quick reference card which comes in the box with the…
view full answer...There are two different locations for your PIN for the Curt Echo Wireless Trailer Brake Controller - 1 to 2 Axles - Proportional #C51180. One is under the cap on the Echo itself. The other is on the quick reference card that came with the Echo. This…
view full answer...The best ball mount that will give you 5 inches of rise is the Brophy Ball Mount #EA60. This ball mount is made from solid aluminum, which means no welded-on parts that can create weak spots, and also means it isn't going to corrode like steel…
view full answer...If your plan was to install a brake controller you'd have to also run the black wire of the 7-Way Adapter part #30717 to the to the positive post of your vehicle battery as well as the ground you mentioned. The Curt Echo part #C51180 that you…
view full answer...If your 2001 Ford F-150 has the factory 4-Way flat trailer connector then you can use harness #118242 to add a 7-Way. Once plugged in in place of the 4-Way harness and after the included relays and fuses are installed then it will be fully functional…
view full answer...I looked up the bolt and nut sizes that come with the Curt weight distribution system part #C17062 and the sizes you need are 3/4", 1-1/8", 1-7/8", and 9/16".
view full answer...I do have an option for you but we have not yet gotten out hands on a 2019 Chevrolet Blazer therefore, have not had the chance to look for the brake controller wiring port either. I checked with both Tekonsha and Curt and it looks like they have not…
view full answer...Curt does offer a Class V hitch that is a confirmed fit for your 2006 Chevy Silverado 1500 HD as the part #C15323 but the part #C15302 is not listed as a fit so it's not the hitch you'll want. I attached an install video for this hitch on a…
view full answer...Filters
- 5 results
Vehicle Fit
