Result: Brake light

Hey Adam, welcome back! Yes, the Roadmaster Comfort Ride Shock Absorbers can be installed without the leaf spring kit. Is this still for your 2013 CrossRoads Elevation TF-3612 with tandem 7k axles? Assuming it is, the #RM-2460 is the kit you need for…

Hey Stephen, yes you can use Lucas Red 'N' Tacky grease in Dexter axle hubs as its very similar to lithium complex EP grease. What axle capacity do you have?

The mounting bolt pattern of the Buyers Products A-Frame Jack #3370091265 is 3" all the way around. The mounting holes are elongated though so if you have a slightly larger/smaller distance it should still work out.

The Replacement O-Ring for Dexter Axle 10K and 12K Disc Brakes part #010-062-00 install on the brake caliper guide bolts between the brake pads as shown in the photo below.

I attached the chart you referenced and it states that when you use a #e54SR spring with a hanger kit part #APS3 the hanger distance should be 24-7/8 inches. The length of a spring when new and not installed on a trailer will be slightly shorter than…

Since you mentioned that you broke a leaf spring and not the axle, in order to determine which replacement leaf springs you'll need for your 2017 Keystone Bullet Premier Ultra Lite Travel Trailer you will need to measure your current springs from…

Based on my research your M1101 trailer has a GVWR of around 3400lbs, so for a replacement axle I recommend taking a look at the Timbren Heavy-Duty Axle-Less Trailer Suspension - Straight Spindle - Off-Road Tires - 3,500 lbs #ASR35HDS01 which will…

It looks like your current brakes use the offset 4-bolt mounting pattern. Take a look at the picture I have included that shows the mounting pattern of Dexter Electric Brake Kit for 4 Bolt or 5 Bolt Flange - 12" - Left/Right Hand Assemblies - 6K…

Hey Henry, thanks for reaching out! I see you already purchased the Curt T-Connector Vehicle Wiring Harness #C55774 which is a great option, especially if you have the USCAR connector on the back of your 7-Way that allows this to be plug and play.…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

If the shackles are flipping the wrong direction frequently that typically means the leaf springs are too short, the hanger spacing is too big, or the shackles are too short. Most of the time it's somebody changed leaf springs and just went with…

Hey Tim, thanks for reaching out! If your 5th wheel is a newer one (made in the 2000's) then it will use industry-standard brakes and hubs. If you can let me know what the weight rating is for your axles then I can let you know what you need. If…