Result: hook

The Curt Breakaway Battery Charger part #C52025 only charges the breakaway battery while the trailer is plugged into the vehicle and the vehicle's battery charge line circuit is active (it could be constant on or keyed with the ignition). Once…

Chrome plating will offer a bit more corrosion resistance than a paint or powder coat finish that can be chipped off. Chrome plating tends to be a bit more resistant to corrosion because of this. The part #C45295 that you referenced would be an…

It really depends on your setup, if the safety chain loops on your tow vehicle are spaced far apart then you will need more slack to make a tight turn then if they were closer together. What I would recommend you do is connect your trailer to your…

Shelby is no longer in business and would not be the same as Fulton; there are no ratchet repair kits available for Shelby so you'll need to replace your winch. Keeping in mind that a boat trailer winch has a boat-size-to-winch capacity that is…

Hey Eli, the etrailer boat winch part #e25VV that you referenced is made of galvanized steel to resist corrosion.

**UPDATE IN COMMENTS** Keep pumping grease into the fittings until you start to see a little grease seeping through the outer bearing. This means that you have packed as much grease as will fit into your spindle. Be sure to check that the grease…

Hi Nate; the Terran Axle Trailer Idler Hub Assembly #TX33VJ uses the standard 3,500 lb bearing combination and grease seal. It has a #L68149 inner and #L44649 outer bearing with a #58846 (10-19) grease seal. If you're looking for a replacement…

Your 6,000lb axle is going to have a larger tube and diameter spindle so there is no way to move your hubs from your 3,500lb axle. We do have replacement 3,500lb axles without hubs you can use to replace your current axle. Here is a list of the sizes…

To replace your AL-KO seal part 363497 you can use the double-lip seal set #RG06-070. These have an inner diameter of 2.250-inches (to match your spindle diameter) and an outer diameter of 3.376-inches (to match the bore on your 12 x 2-inch hub/drum…

The BoatBuckle Kwik-Lok Transom Tie-Down Straps part #IMF13110 are 24" long from the center of each connection so if that is how much space you have between the two tie-down points then they will work. However, a better option is the BoatBuckle…

Hey Kienan thanks for the picture. The only solution I have for you is the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector item #C59236. This is a universal wiring harness that uses clamps instead of splicing and cutting wires.…

We do have an electric over hydraulic disc brake kit that will fit a trailer with two 7000 lb rated torsion axles. In addition to a hydraulic disc brake kit, you will also need a brake line kit, that is compatible with electric over hydraulic brakes.…