Why Choose a Powered Taillight Converter Over a Non-Powered Model
What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...
Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter
Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...
Crossbar Kit Recommendation to Fit with Retrax XR Tonneau Cover on a 2022 Ford Raptor
Hi I have a truck 2022 Ford Raptor with retrax XR tonneau cover with rails compatible with T-slot accessories. Can you please recommend cross bars that would work with the rails on the retrax xr tonneau cover? Thank you | Hey Bora, thanks...
Solution for Trailer Hitch on 2004 Mercedes-Benz CLK 320
Looking for a hitch reciever for a 2004 clk320 benz. Class 1 | Hi Rosemary; I'm sorry to say there are no custom fit hitches available for your 2004 Mercedes-Benz CLK 320. The best solution for a hitch would be to take the # E-911 to a local...
Trailer Hitch and Wiring for 2009 Mercedes R320 Diesel
I have a 2009 mb R320 diesel w251 . The information on the web site indicates the class 2 trailer hitch and separate wiring packages are for a r350 MB the wiring package is with brake controller and 7 way. Can to clarify the correct products...
Grease for U-Joints of 2002 Mercedes Benz CLK320
I have a 2002 mercedes Benz CLK320. I wanna know know the lowest temperature acceptable to grease my ujoint, tierod ends, etc. Thank you | That is a very specific recommendation you'd need to check with a Mercedes dealer over to get an official...
Diagram of the Portion of the Fascia that Needs Trimmed to Install Curt Hitch # C13103
do you have a sketch of how much to trim do you cut around hitch support bar ? | I attached a copy of the installation instructions for the Curt hitch # C13103 which is confirmed your 2007 Mercedes R350. The installation instructions have...
Should Radial or Bias Tires be Used for a 3500lb GVWR Pop Up Camper Trailer
Vehicle - 2011 Coleman Sun Valley pop up camper. Fully loaded - 3500lbs I cant seem to figure out which tire to get. It seems there is much debate on trailer tires, whether to get radials or bias ply. My stock tires are Kenda ST185/80D13-D and...
Is Cutiing Required for Installation of the Mercedes-Benz R350 Trailer Hitch # C13103
I would like to know if there is any cutting of the oem bumper required in order to fit your trailer hitches? | You will not need to cut the OEM bumper for installation of the Curt Trailer Hitch, item # C13103, for the 2008 R350 by Mercedes-Benz....
Shackle Straps Break on a 20ft Tandem Axle Trailer and the Rear Axle Slides the Tires
I have a lawn service trailer. It is approxmently 20 ft. with two 6500 lb. axles. My problem is the rear shackles keep breaking. Ive noticed in tight cornering the rear axle is sliding the tires. What is the proper repair for this situation?...
Trailer Hitch for a 2012 Mercedes R350 BlueTec
Will this hitch also fit the Mercedes 2012 R350 Blue Tech diesel model? Also, where is the best place to get the hitch installed once I buy it? I doubt that a dealer would do the work but I am afraid to trust non-Mercedes technicians, especially...
Trailer Hitch for a 2006 Mercedes-Benz CLK-350 Coupe
My 2006 CLK 350 is a two door Coupe not a convertible/cabriolet. I am not certain that the designated C11353 model will fit a coupe. I have read the available QandA which all pertains to the convertible models and I have studied the instructions...
Removal of Fascia on Mercedes 2008 R350 When Installing a Curt Trailer Hitch, Part # C13103
Once I get the facia off, I can install the hitch. Any tips? Ive removed the 4 bolts under the rear bumper. How do I get the rest of the facia off? CURT 13103 model hitch. | I spoke with my contact at Curt and he informed me that the underbody...
Trailer Hitch and 4-Way Wiring Recommendation for 2018 Mitsubishi Eclipse Cross
I need a hitch and 4 wire harness for a 2018 mitsubishi eclipse cross | For your 2018 Mitsubishi Eclipse Cross we have the Curt hitch # C13273 which is a confirmed fit and then for 4-way wiring you'd want the part # C56296 and you'd be set. |
Ground Clearance of Curt Hitch Installed on 2008 Mercedes Benz R320 CDI
Is the car just too low for a hitch? | For your 2008 Mercedes Benz R320 CDI we have the Curt hitch part # C13103 as a confirmed fit. This will fit your vehicle will and will not sit too low at all. When we installed this hitch on a similar 2006...
Will the Thule Pulse XL Roof Cargo Box Fit on the Factory Crossbars on a 2011 Mercedes R350
Hi, I am planning to purchase the Mercedes Benz Basic Roof Rackinch for my 2011 R350. I would like a roof cargo carrier that will work with the Mercedes Benz rack. Will this box fit on the MB Basic Roof Rack?inch The MB Roof Rack has a channel...
How to Determine Which Replacement Axle is Needed for 1979 Avion Travel Trailer
I HAVE A 1979 AVION TRAVEL TRALER WITH 4 SEPERATE AXELS. THE SPINDEL IS BENT ON THE RIGHT FRONT AXEL, THEREFOR WEARING MY TIRE DOWN WITHIN 3,000 MILES. DO YOU HAVE ANY IDEA WERE I MIGHT PURCHASE AN AXEL? THANK YOU | In order to determine which...
Troubleshooting Rhino-Rack Roof Rack Installation on 2018 Mitsubishi RVR Flush Rails
Ive tried to install the kit of the SX031 legs on my 2018 RVR, but if you look at the pics those legs are not straight on the flush rails so when I have the bars on them then they dont fit anymore... Am I doing something wrong or I got the wrong...
Availability of Hitch for 2006 Mercedes R500
Does this fit a 2006 Mercedes R500? | We offer two different Class III hitches that are a fit for your 2006 M/B R500. Both the Curt # C13103 and the Draw-Tite # 75470 offer a 3500 lb towing/ 350 lb tongue weight capacity, but the warranty requirements...
Torque Specifications to Install the Curt Hitch Receiver C13103 on a 2009 Mercedes-Benz R-Class
The torque setting was not in my instructions. What is the correct torque for the # C13103? | The M10 x 1.50 CL 10.9 fasteners will need to be torqued down to 45 lbs-ft and the 7/16" 59 lb-ft for the Curt Trailer Hitch Receiver # C13103. This...
Solution for Carrying 95 lb E-Bike
I have an e-Cells ebike that weighs about 95 lbs. What rack will be adequate for it? I have a MB R500. | The highest rated e-bike rack we can only carry up to an 80 lb e-bike. We do not have anything aside from motorcycle carriers like the etrailer...
Can a 4-Bike Platform Bike Rack be Used on a 1-1/4 Inch Trailer Hitch on a 2011 Mercedes R350
I have a 2011 Mercedes R350 with a 1-1/4 inch hitch. the label on the OEM hitch states that the car has a 280 pound tongue weight. Can I use the Yakima holdup 2 rack with 1-1/4 inch hitch and add to it the Yakima holdup +2 2 bike add on? ...
Wiring Kit Compatible with 2011 Mercedes-Benz R-Class
Hi, I reviewed questions and eTrailer expert answers related to an R class hitch installation. The thread below caused a bit of confusion: https://www.etrailer.com/question-117319.html. My 2011 should be electrically the same as the 2012 model...
Availability of a Hitch Mount Bike Rack and Trailer Hitch for a 2005 Mercedes CLK 320
Hi, I just bought a 2005 Mercedes CLK 320 and I want to install a hitch and hitch mounted bike rack on it. I like the Swagman 2. Do you think that would work for me. I have a Terry bicycle. They are made for women and the front wheel is...
Filter Your Search
Contact and Help