Winch Recommendation for Lifting 700 lb Sailboat Vertically
I intend to use this winch to retract vertically a 700lb ballasted sailboat centerboard. The winch will sit on the cabin roof and lift the centerboard about 3 feet. I believe the 1500lb capacity is plenty but would prefer a poly strap over...
Hand Winch for Boat Trailer with 20 Foot Long Strap
For the DL 14125 winch the strap specs. is listed for up to a 15foot strap. I have two questions, the first one being can I put a 20foot strap on this winch model and the second question, is the handle on the left drivers sideinch of the winch? Thanks...
Usable Length of Dutton Lainson Linch Pin DL22318
What is the useable length? Measured between the ring and the inside of the ball | I checked with Dutton Lainson and the usable length of the Dutton-Lainson Linch Pin with Ring # DL22318 that you referenced is 2-1/2 inches. |
How To Install Dutton-Lainson Boat Trailer Roller Bunks On Trailer Without Center Supports
Hi There I bought the Roller Bunk 5 a while ago and never was able to install it the problem was that the roller length is 5 and my space between the two trailer support are 9 ft , and i have no inner support to be able to add one in the middle...
Dimensions of Dutton-Lainson Replacement Wheel For Pull Pin, Easy Swivel Trailer Jack, 8 Inch Wheel
Hello, Im in need of an 8inch wheel to repair an old tongue jack. Do you know the inner bore of the wheel and the length of the metal sleeve the bolt goes through? Thanks, | I can certainly provide those measurements for you! I spoke with my...
Solution for Adding Wheel to Jack on 2002 Rockwood Freedom 1980
Greetings, I have 2002 Rockwood Freedom 1980 camper. I would like to get a wheel for the trailer jack so that I could move the camper without the car. My tube outer diameter on the bottom is 1.7 inch. Do you have any solution for the issue? Thanks...
Replacement Trailer Jack For a Trailstar Tracker 175 Boat Trailer
Seems like a perfect replacement for my Trailstar Tracker 175 trailer! Your thoughts please. | The Swivel Marine Trailer Jack with Caster Wheel # DL67MR is a great replacement for the factory jack if you plan on using the caster on smooth surfaces....
How Much Wire Rope Does The Fulton F142412 Hold?
How much wire rope does it hold | The Fulton F142412 can hold up to 24' of 7/16" rope. We have the 25' 5/16" wire rope # DL24102 which would work nicely. |
Recommended Winch For Pulling a Boat Lift Up 40' Of Beach
Have a boat lift that weighs about 1000 lbs. Will be on 4 wheels but when it gets to the beach it is sand and is hard to move. Last year we did it with my DLB1500A Brake Winch, but it was a real struggle. Was looking at the DL3200a and the DL2500...
Availability of 2 inch Diameter A Frame Jack with Sidewind Handle
I need a trailer jack. A frame side winder wit a 2 outer tube. Please advise. Thank you, | We have one sidewind A-frame jack with a 2 inch outer diameter tube, part # DL22530. This is a 1,000 pound jack from Dutton-Lainson that has 15 inches...
Is there an Electric Winch with an 80 Foot Long Cable
Im looking for an elecrical 10 volts winch to be use on a 30 degrees ramp 80 feet long for boats a 20 feet outboard boat with a weight of 2000 pounds, in other words it does not have to be a very strong winch, what I need is a longer cable....
Winch Replacement for Shelby 5404
I want to replace this winch and ordered the suggested replacement which was the Dutton DLB1505A. Unfortunately this base is wider than the Shelby. It sits on 3.75 inch wide plate. Is there another winch I should return it for? Or what other...
Does Dutton-Lainson Drill Drive Socket Adapter # DL6456 Insert Directly Into Power Drill
Do I need an extension or just apply drill to your square crank | You can insert the Dutton-Lainson Drill Drive Socket Adapter # DL6456 directly into your power drill. It has it's own drive so no adapters are needed. |
Picture of a Tipper Latch Installed on a Tilt Trailer
Trailer Tipper Latch by Dutton-Lainson, do you have a pic of how this latch mounts and latches on a tilt trailer? | It's not the greatest quality picture, but I did attach a picture that shows how a tipper latch like the part # DL13353 will...
What Diameter Shaft Will Fit Dutton-Lainson Removable Wheel With Pin For 1981 Boat Trailer Jack
I need a new wheel for my 1981 boat trailer I purchased with my Sea Swirl 18 140 HP I/O Bow Rider Boat. What is the diameter of the shaft that will fit into this wheel? I like the pin idea. When I find the right one Ill drill the shaft to...
What is Mechanical Advantage and How is it Calculated on a Hand Winch
What does the rating Max. Mechanical Advantage mean? Can I add a strap to hand winches that dont show one? Thanks. | Essentially to calculate mechanical advantage, first take the output force and then divide it by the input force. Input force...
Availability of 5,000 lb Top Wind Trailer Jack with Grease Zerk Fitting
Does this unit have a grease fitting? If not can you recommend a 5000 pound top wind jack that does have a grace fitting please? | The A-Frame Trailer Jack - Topwind - 5,000 lbs. by Dutton-Lainson # DL22772 does not have a grease zerk fitting...
Is a Stainless Steel Or Galvanized Steel Cable Stronger When Exposed To The Elements?
I have a very large boat dock that currently has winches attached two trees. My 1/4" aircraft cable broke on one side, which has only occurred 3 times in 17 years. Should I change to a larger winch and 1/2" cable or should I stay with a 1/4?...
How Many Bow Rollers Does a Trailer Usually Have
How many do I need for a 12 ft. alum boat? How far apart should they be spaced? | Normally a trailer only uses one bow roller like the part # YR450BLK that you referenced up near the front of the trailer where the boat rests against the front...
Replacement 1,200 lb Dutton-Lainson Winch Needed for a Tent Trailer
I have a 1973 StarCraft Swinger 6 tent trailer that has a 1200 # DL winch with what looks like an extended bolt which the crank handle attaches too. It is stripped and worn. Crank handle appears to have been modified - extended with pipe and...
Availability of UV Ray Sunlight Resistant Winch Strap and How to Prevent Premature Deterioration
You have quite a selection! Why though, do many of them have one strength rating eg, 4000# in the headline, and another, lower one eg 1400# in the listed specs? Others, the two figures match. Whats the deal? It would also be beneficial to know...
Distance Mounting Plate to Bottom of Wheel Extended and Retracted for Dutton Lainson Jack # DL22300
I have a wood splitter, wanting to get a down wheel jack for it. you have one #DL22300. will this work. how far down will it the tongue and how high for hookups.. | From the center of the mounting plate down to the bottom of the jack wheel...
Recommended Hand Winch to Load and Unload a 500 lb Motorcycle on a Trailer
Hello I would like to purchase a manual winch that my wife can operate as she helps me to load and unload our 500lb motorcycle onto our trailer. I will walk beside the motorcycle on the ramp while she uses the winch to assist me. The trailer...
Does the Dutton Lainson DL11001 Hand Winch Come with Cable Included
does this winch come with cable? and how long is it ? | The Dutton Lainson Hand Winch # DL11001 does not come with cable/wire included and can fit a few different cable diameter sizes: 7/32", 1/4" and 9/32". You can add winch cable like the...
Filter Your Search
Contact and Help