What Diameter Shaft Will Fit Dutton-Lainson Removable Wheel With Pin For 1981 Boat Trailer Jack
Updated 09/27/2010 | Published 09/26/2010
Question:
I need a new wheel for my 1981 boat trailer I purchased with my Sea Swirl 18 140 HP I/O Bow Rider Boat. What is the diameter of the shaft that will fit into this wheel? I like the pin idea. When I find the right one Ill drill the shaft to accept the pin. That is of course you say it will be OK. Many thanks for your help. Best regards,
asked by: Dennis F
Expert Reply:
I walked out to our warehouse and measured the inside diameter of Removable Wheel with Pin, part # DL22539 and it measured 2 inches. Part # DL22539, will fit a shaft with diameter of 2 inches.
Yes, you will be able to drill out a hole for the pin of part # DL22539 to fit the shaft of the jack on your 1981 Boat Trailer, if there is not a hole already there.
Product Page this Question was Asked From
Removable 6" Wheel for Dutton-Lainson A-Frame Trailer Jacks - 2" Inner Tube Diameter
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Wheel
- Wheel w Caster Assembly
- Dutton-Lainson
more information >
Continue Researching
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Is There a Trailer Wheel with a 5 on 4-1/4 inch Bolt Pattern
- Article: Big Truck Big RV
- Q&A: Recommended Skid Wheel For 14 Foot Pace Enclosed Trailer
- Q&A: Low Clearance A-Frame Trailer Jack that Can be Fitted with a Wheel or Footplate
- Q&A: Can I Determine the psi Rating of a Wheel
- Q&A: Recommended Caster Wheel for a 1 3/4" Jack Tube
- Q&A: Choosing a Replacement A-Frame Trailer Jack for Pop-Up Camper
- Q&A: Caster Wheel Recommendation for Trailer Jack with 1-3/4" Tube Diameter
- Article: Best Camper Jacks
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams