Result: Boat Loading Guide

The Caliber Bunk Wrap Kit for 2x6 Boat Trailer Guides item # CA88AJ fits two 2" x 6" bunk boards up to 8' long. | I own a pontoon boat. Each bunk has 2 - 2x6x16 boards. Does one kit cover both boards or do...

Hello Harold, Looks like you already found the longest ones we have, the CE Smith Carpeted Bunk Boards for Boat Trailers - 7' Long - 1 Pair # CE27845. For some 10' boards, I would go to your local hardware store to get some 2"x4" Pressure-Treated Southern Yellow Pine, then you can add the Caliber Bunk Wrap Kit for 2x4 Boat Trailer Guides - 16' Long - Black # CA38AJ. |

Is the Caliber Bunk Wrap Kit for 2x6 Boat Trailer Guides - 16foot Long pre cut for two 8’ wraps or is it the full 16’ length? | Is the Caliber Bunk Wrap Kit for 2x6 Boat Trailer Guides - 16foot Long pre cut...

You've got a pretty heavy fiberglass boat, and that ShoreLand'r trailer uses all those bunks for a reason, to spread the load out across a lot of hull surface area. | I was thinking about putting rollers on...

Now you'll have way less friction when loading or unloading your boat :) | I’ve got four 6-foot bunks on my trailer. I saw that one set is 10 that are 3inch wide and 15inch long – or CA58AJ is smaller... how...

This helps avoid concentrating the load on a narrow strip. The 1-1/2" slides are better suited to smaller boats, pontoons, or PWCs. | My 25’ proline weighs 5000 lbs. will your caliber boat slides support this...

It's also 3 separate pieces so you're going to get quite a bit of movement to help with the loading process. What kind of boat do you have? | I normally have to lift my boat up and over my bow stop, but I...

Will this help with my ‘05 F250 w/a 6” lift, that’s typically loaded with tools and pulling a 24’ boat w/ a large motor sway and sag are my main issues? | Will this help with my ‘05 F250 w/a 6” lift, that’s...

The RAS gives up to 2000-lbs of load support so it will be ideal for your combination of camper weight and trailer tongue weight. | I have a 2018 Nissan Titan and I plan on purchasing this product but I need to know if it...

For your 2019 Ford F-150 Raptor towing a 6000lb boat I recommend using the RoadActive Suspension Leaf Spring Enhancement Kit # RAS3611 you purchased as it will be the best at preventing sag like you are experiencing, but will also eliminate axle wrap and minimize sway and body roll giving you a better driving experience loaded or unloaded. |

I put a slide in pop up camper in the bed that weighs 1100lbs and tow a smaller boat with about 100lbs of tongue weight. The camper is fairly easy to load and unload so I keep it unloaded when not using. ...

Keep in mind that suspension upgrades improve ride and handling but do not increase load capacities. | In need a Heavy Duty Roadmaster Active Suspension Kit for a 2002 Chevy Suburban 1500, 4x4. | RoadActive # RAS4611 Active...

If you're looking for the smoothest loading possible, I'd extend the slides over as much of the contact area as practical, especially near the rear of the trailer where most of the loading friction occurs. ...

Currently, there is no sag with the popup loaded. Do you suggest air springs and if so do you have any that are no-drill? | I have a 2005 Toyota Tundra 4WD with 265/70R16 tires. Ive just added a popup camper on the back and...

I pull a tandem axle ski boat and dont like when i hook the boat up , it looks like it is squatting. | I have 2001 gmc sierra 1500 LD 2 wheel drive extended cab truck. My truck has a 3 inch lift on it. I...

is there just one size or one weight capability, i.e. medium load size vs heavy load size. Do not need to handle extreme heavy loads, just pulling a large fishing boat. |...

A couple of “nice-to-have” items that a lot of people end up adding later are: etrailer Anti-Rattle Hitch Collar # e38FV etrailer Hitch Pin Alignment Collar # e98942 Those just help tighten everything up and make hookups a bit easier. What kind of boat are you going to be loading up on that trailer? |

I tow a 20ft Skeeter boat on a tandem trailer which all total is about 4500 lbs. | I tow a 20ft Skeeter boat on a tandem trailer which all total is about 4500 lbs. I use it two to three times a week. What would be the best...

The Caliber Bunk Wrap Endcaps part # CA48AJ are designed to fit standard 2x4 lumber, so they can be installed on the ends of your clothesline cross beams just like they would be on a boat trailer guide. I actually think that is a pretty clever use for them since they will give you a much smoother, more visible end to the boards and help eliminate those painful head bumps when mowing around the yard. |

I will be towing a 6K lb boat. Ive narrowed down my options to the Firestone sport ride air bags and the Roadmaster Active Suspension Custom Leaf Spring Enhancement Kit. | I have a 2004 GMC Sierra 1500 Z71. My goal is to improve...

The air bags reduce the strain on your rear suspension, increase safety, and compensate for uneven loads. They level your truck from front to back and adjust independently for side-to-side leveling of off-center loads. |

We tow a single axle trailer with a comp ski boat. It has a lot of tongue weight, when loaded I’m almost to the bump stops. | I’m always one of excess or overkill and don’t want to have the wife upset on her...

It is a RWD, and I use it for towing relatively often. My heaviest towing load is around 6,000 lbs my boat, but I do not tow that too often. | Which of the Road Master Active Suspensions are made for my vehicle?...

Once the wraps are on, you’re pretty much done with bunk maintenance since they don’t hold water or wear down like carpet, and they make loading and unloading a lot smoother. What kind of boat do you have?...