Search: Wheel Locks > Wheel Chocks >
Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey John! The Trimax Trailer Wheel Chock and Lock #TMX72ZR is designed to fit 6" to 10-1/2" wide tires. It looks like the 2024 Rockwood Mini-Lite 2104S came with ST205/75R14 tires which are typically 8" wide. Assuming those are the…
view full answer...Hey Steve! The area you have to trim to install the Curt #C69RJ isn't too big or complicated so it should be pretty simple. See the attached photo. It comes with a diagram to help guide you and I would use a Dremel to make the cut. If you…
view full answer...Hey Dallas! What is your goal with your setup? If the best clearance is what matters, and you don't want to have to worry about figuring that out, a sliding 5th wheel hitch is a simple solution. For that I recommend the B&W Companion…
view full answer...Hello Tri, I’m going to recommend going with the first part number. The Trimax Trailer Wheel Chock and Lock - 6" - 10-1/2" Wide Tires - Qty 2 #TMX72ZR will work well with your ST235/75R15 tires, which are 9-1/2" wide at max PSI. The…
view full answer...The most likely scenario that would lead to your right tail light staying on even after it is unplugged is that somewhere along the wires running through your trailer, there is an inadvertent bare connection between your right tail light wire and the…
view full answer...Hi Bill; are you talking about a hitch where only the receiver is visible at the rear like the #C22HR for the Pilot? This is the same hitch pictured below. The Curt Trailer Hitch Receiver #C69RJ is confirmed to fit your 2026 Honda Passport RTL and…
view full answer...Hey Michael, if you replace your Magnetek 6325 with the WFCO #WF96FR it will be compatible with lithium batteries like what you have now as this comes with a lithium charging profile. If you are asking if the #6325 is lithium compatible it was not.…
view full answer...Hey Tony, a 2018 Ram 2500 would not have had a 3 inch hitch installed on it so the Weigh Safe #WS64WR that you referenced would not work. Instead your truck would have had a 2-1/2 inch hitch installed on it and you'd need the part #WS52ER instead…
view full answer...Hey Gus! Yes, the Trailer Coupler for Yakima Rack and Roll Trailers - 2" Ball - Bolt On #Y08123 will fit your older Rack and Roll trailer 8008106. It is the same coupler for the old model and the current #Y08107. This does not come with hardware…
view full answer...It sounds like the power from the trailer battery is somehow reaching the right brake and turn signal circuit. The brake and turn signal circuit on the trailer should not be connected to the trailer battery. The first step I would take is to check…
view full answer...The CLUB Tire Claw XL #WI491 appears to be the wheel lock that will fit your wheels and tires. It can fit wheels up to 12" wide which your tire is 10" wide, and will extend into the wheel up to 8" from the tread face. Your side wall is…
view full answer...Hey Val! Is it similar to the etrailer Coupler Lock #e98888? I tried looking up that part number online but was unable to find anything about it. Feel free to shoot any photos to me in a reply to the email you received from me if the lock design is…
view full answer...