Search: Ground Control 3.0   >   Trailers   >   4800 lbs  x   >  

It sounds like you just need to reset the zero point. In order to do this you will need to follow the steps I have attached for you below and in the photo. If this does not fix your issue then please just let me know and I will see if we have any…

I reached out to Lippert and your 346005 control module was replaced with the Replacement Control Module for Lippert Ground Control 3.0 Leveling System #LC85ED. To use this control module they said you must have the Control Panel #LC421484…

If you have the Lippert Ground Control 3.0 then your middle jack is either the 17" Tall #LC342610 or the 19" Tall #LC305339. I'm not sure where you would be able to find a part number but if you check out the attached photo you can take…

The Replacement Control Module for Lippert Ground Control 3.0 Leveling System #LC85ED is part of the Ground Control system that does have a wireless remote compatible with it like the part #LC358601. It is not a BlueTooth connection though.

When selecting the correct replacement axle for a utility trailer you will need to know both the hub face (wheel center) and spring center measurements. For example, if your current hub face measurement is 88" and you replace this with an axle…

There sure is! If you use the provided links, you can see both the owner's manual which shows how to use the system as well as the installation instructions. I'll also link to a video showing a typical installation, which you might find…

The rear leveling sensor 232201 for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 4-Point Set #LC358590 on your 2016 Sanibel 5th Wheel is located towards the rear of the trailer, a bit behind the rear…

We have heard of this issue before on the Lippert Ground Control systems #LC358590. Here is the recommended procedure for clearing the error code: Extend all jacks at least 6 inches. Then press and hold the RETRACT button until the jacks begin…

No, the hall effect motor does not have to be greased, but per the service manual if the jacks are down for an extended period, it is recommended to spray the exposed leveling jack tubes with lubricant every 3 months for protection. If you live in a…

Do you get any error code on the controller for the Lippert Ground Control 3.0 #LC675817? Usually that helps to troubleshoot and the manual gives an exact solution for each error code. You might also try resetting the Zero Point Calibration to see if…

Yes, the Replacement Right Rear Leg #LC344792 is the correct unit to replace the rear passenger side jack on your Lippert Ground Control 3.0 System. I reached out to my contact at Lippert and he said there aren't any specific torque specs that…

Based on the model numbers you provided, it appears that you currently have the Lippert 3.0 Electric Leveling System installed on your trailer. For a replacement motor, you will just need the Lippert Replacement Motor #LC343758. This will serve as an…